If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
"Clunk", my hub?
Michael Horowitz wrote:
> On Mon, 28 May 2007 13:56:53 -0400, jrchilds > > wrote: > > >> You seem to get it, there are 2 u-joints, one on each end of the >> driveshaft, plus a cv(constant velocity)joint in the middle of it. >> > Hmmmm. We may have a disconnect. It appears the CV joints are on the > forward axles. What I"m describing is the joint that fits into what I > believe is the transfer case; a 'box' that is attached to the side of > the xmission. - Mike > Yep, my front driveshaft has a small rubber bellows covered section in the middle, figured it was another cv joint. Has U-Joints at both ends. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transmission Question - "clunk" noise when shifting | Gene[_4_] | Ford Mustang | 1 | April 5th 07 08:13 PM |
93 ZJ "clunk" in front axle | Ron Croonenberg | Jeep | 26 | March 29th 06 11:57 PM |
Volkswagen exposes the swastika as "S" for "socialism" - known as the "swastika hubcap" car, the VW hubcaps (when spinning at certain speeds) remind some people of the symbol of the National Socialist German Workers' Par | rexcurrydotnet | Driving | 0 | February 23rd 06 06:23 PM |
"Clunk" in front end of 2000 Neon | Lancerific | Chrysler | 1 | October 19th 05 11:44 AM |