If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
OT learning it the hard way
Ok, i bet everyone did something stupid while working on his ACVW.
Today it was my turn..... I wanted to check the timing on my bug with a strob-light but the sparkplug connectors did't mach both sides. I remembered that there were little brass thingies that came allong with the plugs so i twisted them on the top of the plug and yes, one side fitted on the strob. To fix the other end i wanted to do the same there but then i needed to open/trash an old plug... you guessed it i did this partially with bare hands.... STUPID!! I ended up with a cut in my thumb bleeding like ....my grilfriend can... Could not see if it was deep or not cause of the blood so i went to the emergency and let them have a look. In the end it was not so bad and did not needed a good ol' fashion needle work and had more paperwork than 'real' work. The good thing is i've got my teanus shot so i can hurt myself for the next 10 years! O, the strob still doesn't fit..... Greetings from stupid |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What to do with the soft top hardware when reinstalling the hard top? | [email protected] | Jeep | 5 | April 19th 05 04:22 PM |
Hard steering , feels like power steering has gone south | Pepper | Technology | 0 | April 3rd 05 01:23 AM |
Hard starting problem dodge 360 | [email protected] | Technology | 9 | March 20th 05 11:57 PM |
Xpand Rally- mostly good, but hard | magnulus | Simulators | 0 | January 29th 05 08:16 PM |
switching hard dog rollbars | pws | Mazda | 0 | November 18th 04 11:03 PM |