If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
96 blower motor resister location
Would someone please direct me to the exact location of the blower
motor resistor on the 96 Explorer. Also any replacement instructions.Thank you. Paul |
Ads |
#2
|
|||
|
|||
Sure, It is accessed from the engine compartment just below and inboard of
the blower motor. About 6-8 inches away. Held in by a couple screws. Tough to get at so be patient. No particular instructions. There may be some wiring to do since connector on replacement may be different. This is where the one for my 96X was. My temp controller was an Automatic unit. Presume same goes for a manual unit. Jerry > wrote in message ... > Would someone please direct me to the exact location of the blower > motor resistor on the 96 Explorer. Also any replacement > instructions.Thank you. > Paul |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
location of fuse for E39 A/C blower | CFL | BMW | 2 | March 31st 05 04:12 AM |
1996 Dodge Grand Caravan LE AC/Heater Blower, Relay and Resistor Block Problems 101 | HeadlessHorseman | Dodge | 0 | January 5th 05 02:49 PM |
Heater Blower Upgrade Question | Michael White | Jeep | 16 | December 9th 04 01:41 PM |
97 GC - Mechanic Cant find Blower Relay - Found | PoBoy | Jeep | 1 | November 30th 04 09:57 PM |