If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Oh.
I bet the motor is worn out. The brushes in DC motors wear out. (motors with brushes are cheaper than brushless motors - guess which ones car makers use?) I bet that as you turn left, the brush is pushed against the commutator and it starts spinning. As you turn right, the brush is pushed away. I'd check out the motor. "carnovice" > wrote in message ups.com... > > Bob Shuman wrote: >> My (possibly incorrect) understanding is that the OP is saying that > the >> blower really does not work most of the time at all, regardless of > the fan >> position switch. But, occasionally, when they turn left the fan will > start >> to blow at whatever speed the position switch is set, and then when > the turn >> is completed it does not work again. > > > YES! YES! I HAVE FINALLY BEEN UNDERSTOOD! I APLOGIZE IF MY THOUGHTS > DID NOT FLOW SMOOTHLY. Bob is correct in his restatement of my > problems. THANKS! > > So, I suppose I'll need to take this to the dealer for an autopsy? Any > home remedies out there? > |
Ads |
#12
|
|||
|
|||
So, where can I find a diagram showing me where the blower motor is
located? |
#13
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 7 | February 1st 05 01:43 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | January 2nd 05 05:15 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 18th 04 05:15 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 2nd 04 05:19 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 16th 04 05:28 AM |