If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cruise n/w after removing master cyl switch
I don't know if this was brought up before, but when I removed the
wiring to the hazardous cruise disconnect switch on the master cylinder, my cruise no longer works. I thought someone said that the cruise would still work, but I would have to press the off switch to disengage it. I normally do not use the cruise. I was just curious and tested it out. |
Ads |
#2
|
|||
|
|||
Your correct. Thats what that individual said. But thats not the way
its suppose to work. Your observation is what is suppose to happen I believe. That switch is normally closed and provides power to the speed control. When you press the brake or disconnect the switch, thus opening the circuit, the cruise should cease to function. I've got a 2002 and my brake switch is only powered with the ignition switch on. I'm leaving it connected and am going to quit being concerned about it. |
#3
|
|||
|
|||
If you unplug that switch in the master cylinder and just short out the
harness side connector terminals, then the cruise module will get power all the time. To disengage cruise, you'd step on the brake pedal, and if that doesn't disengage it (failsafe mode), then press the OFF button on the stg wheel. And if THAT doesn't work... better shut off the ignition !!! "HerkyJerky" > wrote in message oups.com... > Your correct. Thats what that individual said. But thats not the way > its suppose to work. Your observation is what is suppose to happen I > believe. That switch is normally closed and provides power to the > speed control. When you press the brake or disconnect the switch, thus > opening the circuit, the cruise should cease to function. > I've got a 2002 and my brake switch is only powered with the > ignition switch on. I'm leaving it connected and am going to quit > being concerned about it. > > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cruise Control Slow Turning On Odyssey 98 | Ted Leja | Honda | 0 | March 20th 05 05:29 PM |
'93 SC2 Cruise schematic??? | Philip Nasadowski | Saturn | 3 | January 6th 05 08:48 AM |
About Kent Finnell (but you knew this already) | Boston Blackie | Honda | 2 | January 4th 05 10:00 AM |
'97 Voyager - Brakes | MamaB | Dodge | 20 | December 6th 04 12:26 AM |
Ign Switch Failure examination 91 B3 | dave | VW water cooled | 0 | October 2nd 04 04:46 PM |