If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
94 Civic: handbrake failure on one side
I finally had an opportunity to investigate the handbrake problem I
raised some weeks ago. Not as simple as I would've hoped. I've got rear disc brakes, so the handbrake cable attaches to the "parking brake arm" as described in the service manual (p. 19-5). This arm apparently attaches to a shaft that descends into the caliper and activates the caliper piston when the handbrake is applied. The problem is that the arm on the problem (left) wheel pulls all the way around to the caliper pin stop without engaging the pads--it's like it's disconnected from the shaft, or perhaps the shaft has sheared. On the right it pulls merely 1/4" before the brake is engaged. Visibly, everything appears to be in place on the left as on the right, though I haven't yet removed the return spring and tried the parking nut that attaches the arm to the shaft (didn't have the right tools with me. grrr.). George MacD. suggested, among other things, that it could be a bad self-adjusting piston, but I don't think that's the case here given that applying the brakes with the foot pedal appears to properly apply the brakes on the left wheel. It'd be nice if it's just a loose nut, but somehow I doubt that. ;-(( Is there anything I should know about that nut before I start working at it? As in, how can one keep the shaft from turning while removing the nut, for example? I'm worried that the shaft has sheared and I'll have to replace it. Are there any tricks to replacing it--if it's even possible to do so without specialized shop tools? I'll probably be able to investigate the shaft in a week or so. [BTW, anyone know which shaft is which--Shaft A and Shaft B are described at the slhonda.com parts site. If I can judge from the image number positions, "A" would correspond to the right side while "B" would correspond to the left, but confirmation would be appreciated.] Eleven bucks for a new shaft would be a hell of a lot better than $190 for the whole blasted caliper... Thanks for any helpful input. Abe |
Ads |
#2
|
|||
|
|||
Abeness wrote: <snip> > George MacD. suggested, among other things, that it could be a bad > self-adjusting piston, but I don't think that's the case here given that > applying the brakes with the foot pedal appears to properly apply the > brakes on the left wheel. The self-adjusting mechanism adjusts the hand brake only. If the mechanism does not work, the foot brake will not be affected. Short of picking apart the brake caliper, you could try pushing the piston all the way back into the caliper (rotating clockwise as you push it in, just like you would do when replacing brake pads.) Put the caliper back on and pump the foot brake until it is firm. See if the hand brake does anything now. With a great deal of luck, this will jiggle the mechanism just enough that it starts working again. I have the same problem on an old VW GTi, I am planning on picking up a complete caliper at the junk yard. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |
FA: 04 HONDA CIVIC PASS SIDE TAIL LIGHT OEM | its4pla | Honda | 0 | September 24th 04 12:08 AM |
ISO: information on fairly narrow, driver's side pumpkin, front axle | [email protected] | 4x4 | 0 | February 7th 04 08:31 PM |