If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2000 Chrysler 300M map light
Bulb burned out in overhead map light. How do I change it? Seems like
the cover should just pop off but it doesn't - at least easily. Trying not to break the cover - just want to change the bulb. Thanks. ST |
Ads |
#2
|
|||
|
|||
2000 Chrysler 300M map light
|
#3
|
|||
|
|||
2000 Chrysler 300M map light
did you figure it out? i'm having the same problem.
|
#4
|
|||
|
|||
2000 Chrysler 300M map light
> wrote in message ups.com... > > wrote: > > Bulb burned out in overhead map light. How do I change it? Seems like > > the cover should just pop off but it doesn't - at least easily. Trying > > not to break the cover - just want to change the bulb. Thanks. ST > 1.. Remove screw from windshield side of console. 2.. Grasp the front of console and pull downward to disconnect the retaining clips. Glenn Beasley Chrysler Tech |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 16th 04 05:28 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 1st 04 05:24 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | October 16th 04 05:28 AM |