If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How do you remove the timing belt sprocket from front camshaft, 90 Dodge Spirit?
Trying to replace a leaking oil seal at the front of the camshaft.
I've got the timing belt off, and the pulley, and have removed the bolt that secures the sprocket to the front of the camshaft. The service manual shows a flat puller being used, the kind where you secure it to the sprocket using the threaded bolt holes on the sprocket and turn a bolt throught the middle that pushes the flat plate (and anything it is bolted to) away from what the center bolt is pushing against. The sprocket they show has 4 holes, and the photo shows a puller attached to 2 holes on opposite sides, so the pulling force is even (straight off of the shaft). The sprocket I am trying to remove has 5 holes, so none line up directly across from each other. I've tried a harmonic balancer puller, which has two holes directly across from each other and 2 more at about 45 degrees from one of the other holes, - 2 holes line up, but since they are not directly across from each other, the pulling force is not straight off of the shaft, and all I did was bend the bolts holding the puller on. Any suggestions? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
'89 525i timing belt woes | [email protected] | BMW | 15 | December 31st 04 06:37 PM |
2001 change timing belt or not? | Buying a Used Audi | Audi | 16 | December 27th 04 05:02 PM |
Oil Leak after Timing Belt Change | Jonathan Goodish | Audi | 7 | December 22nd 04 01:47 AM |
Timing Belt Change | Simon | Audi | 10 | August 26th 04 04:52 AM |