If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Head Gasket replacement
What's the best way to tear down the 2.5 head in a '90 Horizon - pull it
with manifolds and disassemble on the bench or pull off the pieces while head still bolted to block? Going to attempt my first head gasket replacement soon as it warms up! Could use any tips/pointers. |
Ads |
#2
|
|||
|
|||
remove the head with intake and exhaust,,very easy job, the hardest thing
you may run into and removing the exhaust flange bolts, Glenn Beasley Chrysler Tech "Randy Bishop" > wrote in message 6... > What's the best way to tear down the 2.5 head in a '90 Horizon - pull it > with manifolds and disassemble on the bench or pull off the pieces while > head still bolted to block? Going to attempt my first head gasket > replacement soon as it warms up! Could use any tips/pointers. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1.5 civic non vtec cylinder head gasket questions. | Gerry | Honda | 4 | February 28th 05 05:26 AM |
Head Gasket Help | Dave Skirrow | Technology | 17 | January 17th 05 05:46 PM |
Head Gasket Leak? | maxpower | Chrysler | 4 | October 11th 04 03:00 PM |
Head Gasket Leak? | Mandrake | Chrysler | 0 | October 10th 04 10:16 PM |
Gasket replacement - 1992 525i | Scott | BMW | 6 | October 2nd 04 04:02 AM |