If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#17
|
|||
|
|||
Bill, I couldn't identify Fuse No. 19 in the Pwr Dist Ctr so I left
them all out for several minutes! According to the owner's manual No. 19 fuse is actually located on the fuse panel inside the car. Just to clarify how the circuit works........... when I depress the trunk release button the signal is sent from the button to the BCM and then the BCM energizes the trunk release if all the perameters are met, i.e., trans in N or P????? If this is correct then I should be able tie in a short lead off the Blk/W wire coming from the BCM to verify that the BCM is actually transmitting the signal. I suppose that before I do this I'll have to crawl back under the dash and try to manipulate the grey plug back in place..... I'm not looking forward to it! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1997 Dodge Intrepid engine rebuild problem? | crb | Dodge | 9 | July 19th 05 09:18 PM |
Electrical or a transmition problem in a 94 Intrepid | beneteau1983 | Chrysler | 0 | June 11th 05 06:36 PM |
Disabling the console trunk release | XS11E | Mazda | 10 | March 4th 05 12:09 AM |
1997 Intrepid Trunk Help | Glen Sletvold | Chrysler | 2 | November 28th 04 07:23 PM |