|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
July 8th 05, 07:54 PM
|
|||
|
|||
L.W. ("ßill") Hughes III did pass the time by typing:
> I bet your amp could use the same ducts. It has them.  Routed from each of the rear seat floor ducts using sump pump tube tucked under the carpet. > DougW wrote: >> >> If I were to place a bet, I'd say the foam duct seal moved out of the way >> when they put the vent in. Had a similar problem in my ZJ and all it took >> was taking the plastic cover off, moving the foam seal back to where it >> should, then putting the whole thing back on. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 98 Explorer - Cold Starting/ Idle Problem | tj | Ford Explorer | 6 | March 16th 05 03:22 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 18th 04 05:15 AM |
| rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 2nd 04 05:19 AM |
| New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |
| 87 TBI Suburban bog / acceleration problem | Michael Vosk | 4x4 | 8 | September 29th 04 04:55 AM |
Threaded Mode