If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1984 Plymouth Reliant (2.6L) still idles way too fast...
I got my hands on the Chrysler FSM. Can't say as it has helped me all that
much. Vehicle in question is a 1984 Plymouth Reliant with the Mitsubishi 2.6L engine. As best I can tell (although the pictures in the FSM still don't quite match), the car is equipped with the "feedback" type Mikuni carburetor. There is a throttle position sensor on the carb, which the non-feedback type does not seem to have. Fresh fuel helped somewhat with the dieseling, but when fully warmed up, it will still diesel when shut off. Connecting a tachometer to the engine shows it idling around 2000 RPM. Sometimes the car will start and idle nicely for a brief period of time, maybe a few seconds. Then it throttles up and takes off. I'm running thin on ideas. Can anyone help? Thanks in advance for *any* answers, suggestions, thoughts, etc... William |
Ads |
#2
|
|||
|
|||
1984 Plymouth Reliant (2.6L) still idles way too fast...
I just had a similar problem earlier today with the same year and make
of car. From what I have been told, one of the vacuum lines is loose or disconnected and the car is sucking way too much air. I have not found the idle screw but will report where it is late tonight. Would you know where to find the vacuum line diagram? Rob On Jul 3, 5:27 pm, "William R. Walsh" m> wrote: > I got my hands on the Chrysler FSM. Can't say as it has helped me all that > much. Vehicle in question is a 1984 Plymouth Reliant with the Mitsubishi > 2.6L engine. As best I can tell (although the pictures in the FSM still > don't quite match), the car is equipped with the "feedback" type Mikuni > carburetor. There is a throttle position sensor on the carb, which the > non-feedback type does not seem to have. Fresh fuel helped somewhat with the > dieseling, but when fully warmed up, it will still diesel when shut off. > > Connecting a tachometer to the engine shows it idling around 2000 RPM. > > Sometimes the car will start and idle nicely for a brief period of time, > maybe a few seconds. Then it throttles up and takes off. > > I'm running thin on ideas. Can anyone help? Thanks in advance for *any* > answers, suggestions, thoughts, etc... > > William |
#3
|
|||
|
|||
1984 Plymouth Reliant (2.6L) still idles way too fast...
Hi!
> I just had a similar problem earlier today with the same year and make > of car. From what I have been told, one of the vacuum lines is loose > or disconnected and the car is sucking way too much air. I have not > found the idle screw but will report where it is late tonight. Would > you know where to find the vacuum line diagram? The one in my car is printed underhood, where the hood meets up near the windshield. If yours is gone, I could try photographing mine and posting a link. There's also a diagram in the FSM that I might be able to scan. (My scanner is somewhat precariously balanced and might not stand having a Chrysler FSM thrown upon it...!) Something else to check--make sure the secondary on the carb is *not* stuck open. If it is, you'll have a racing engine. I freed it up and now everything works...properly. The idle adjustment is now both possible and effective. The car drives a lot better too. (Yeah, I know...that sounds like a "well, duh!" thing to say, but...). I have noticed something of a "flat spot" when getting up to speed, but I really don't care to look into it. William |
#4
|
|||
|
|||
1984 Plymouth Reliant (2.6L) still idles way too fast...
On Jul 3, 6:27 pm, "William R. Walsh"
m> wrote: > I got my hands on the Chrysler FSM. Can't say as it has helped me all that > much. Vehicle in question is a 1984 Plymouth Reliant with the Mitsubishi > 2.6L engine. As best I can tell (although the pictures in the FSM still > don't quite match), the car is equipped with the "feedback" type Mikuni > carburetor. There is a throttle position sensor on the carb, which the > non-feedback type does not seem to have. Fresh fuel helped somewhat with the > dieseling, but when fully warmed up, it will still diesel when shut off. > > Connecting a tachometer to the engine shows it idling around 2000 RPM. > > Sometimes the car will start and idle nicely for a brief period of time, > maybe a few seconds. Then it throttles up and takes off. > > I'm running thin on ideas. Can anyone help? Thanks in advance for *any* > answers, suggestions, thoughts, etc... > > William These Minuki carbs were notorious for being hard to adjust. Some of the adjustment screws were covered, to prevent tampering. It seems like Holley or one of those offered a replacement, but I can't remember for sure. -KM |
#5
|
|||
|
|||
1984 Plymouth Reliant (2.6L) still idles way too fast...
Hi!
> These Minuki carbs were notorious for being hard to adjust. I see some of the covered screws ("tamper resistant idle mixture screw") in the FSM. Fortunately, it seems like the adjustments are pretty much correct. I've found and fixed the following problems: Stuck choke (stayed open or closed all the time) Stuck secondary barrel damper (now opens and closes like it should) The car now runs correctly, idles down as it should and seems to be doing well. Yesterday it acted like it was going to run out of fuel if I so much as dared to touch the gas pedal and it wouldn't idle properly. So I pulled the fuel filter and drained it to find that there was a bunch of trash in there. The Autozone-branded replacement wouldn't flow fuel at all (it seemed to have something causing total blockage), so I fashioned a straw to join the two hoses and went for a brief test drive. Performance was much better and fuel flow was clean and even. I'll get a better filter. Every problem I've run into so far has been result of something being stuck, dried out, rusty or all of the above. In other words, I think that I've just about got it. William |
#6
|
|||
|
|||
1984 Plymouth Reliant (2.6L) still idles way too fast...
On Jul 26, 3:11 am, "William R. Walsh"
m> wrote: > Hi! > > > These Minuki carbs were notorious for being hard to adjust. > > I see some of the covered screws ("tamper resistant idle mixture screw") in > the FSM. Fortunately, it seems like the adjustments are pretty much correct. > I've found and fixed the following problems: > > Stuck choke (stayed open or closed all the time) > Stuck secondary barrel damper (now opens and closes like it should) > > The car now runs correctly, idles down as it should and seems to be doing > well. Yesterday it acted like it was going to run out of fuel if I so much > as dared to touch the gas pedal and it wouldn't idle properly. So I pulled > the fuel filter and drained it to find that there was a bunch of trash in > there. The Autozone-branded replacement wouldn't flow fuel at all (it seemed > to have something causing total blockage), so I fashioned a straw to join > the two hoses and went for a brief test drive. Performance was much better > and fuel flow was clean and even. I'll get a better filter. > > Every problem I've run into so far has been result of something being stuck, > dried out, rusty or all of the above. > > In other words, I think that I've just about got it. > > William I worked on a Corolla one time that had a major dieseling problem on shut off. Actually, it would *never* shut off unless you put your hand over the carb and choked it out. The problem turned out to be a faulty vacuum advance (or retard) mechanism in the distributor. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1984 Plymouth Reliant idles way too fast... | William R. Walsh | Chrysler | 3 | June 18th 07 11:47 PM |
1984 Plymouth Reliant AM Radio | maxpower | Chrysler | 7 | June 15th 07 02:47 PM |
Buick V-6 3.8 Idles Fast in Drive (But idles normally in Neutral) | Gene Gardner | Technology | 2 | March 17th 06 02:09 AM |
1985 Toyota Pickup -- Idles Too Fast | Daniel B. Martin | Technology | 9 | September 14th 05 02:14 AM |
87 Cherokee 4L idles very fast sometimes | DDKreiter | Jeep | 2 | January 31st 05 01:06 AM |