If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cleaning idle air control valve on 99 accord 4 cylinder
Hello. I am having trouble with stalling at idle and would like to
clean the idle air control valve and throttle body. Do I need to remove the throttle body to get to the IACV? I removed the bolts for the throttle body, but can't seem to break it free from the intake manifold. Does anyone have a suggestion as to how to get the throttle body free? Otherwise, I will have to clean the TB from the front, but access to the IACV seems pretty limited. Thanks for any help. Rich |
Ads |
#3
|
|||
|
|||
Cleaning idle air control valve on 99 accord 4 cylinder
> See part#9? That's your IAC. You don't remove the throttle body
> or its bolts to clean it, and chances of you actually needing to > clean the IAC are slim. Yes, I need a shop manual, but I do know that #9 is the IAC. It just seems difficult to access without taking off the TB. > Is the engine cold, warming up, or hot when it stalls? The engine is hot. > Does it stall when coming up to lights, or when already stopped? It stalls occassionally in stop and go traffic (I think when already stopped). > How long will it idle until it stalls? Most of the time it idles ok. The stall is intermittent. > What speed is it idling at before it stalls? Under 1000 rpm. It is hard to tell what the scale is, but usually it's one mark under the 1000 mark. The idle tends to drift a bit above and below this mark. > How old are the plugs and plug wires? I just replaced the plugs with NGK this month. I had a misfire last month while idling and figured it was time to replace the plugs (they were 4 years old with about 25k on them, but didn't look too bad when I took them out). The wires are original. The car is a 99 with 47k miles. |
#4
|
|||
|
|||
Cleaning idle air control valve on 99 accord 4 cylinder
wrote in
ups.com: <snip> > > >> What speed is it idling at before it stalls? > > Under 1000 rpm. It is hard to tell what the scale is, but usually > it's one mark under the 1000 mark. The idle tends to drift a bit > above and below this mark. Oho, so it's fluctuating! An interesting piece of information. The idle should be rock steady. At idle, full warm, you should be 750rpm in Drive. If you're around 1000rpm and fluctuating at that, I must ask these questions: 1) When was the last time the cooling system was drained and refilled? 2) How old is the thermostat? 3) What does the fluid look like when you pull the rad cap (cold!) > >> How old are the plugs and plug wires? > > > I just replaced the plugs with NGK this month. I had a misfire last > month while idling and figured it was time to replace the plugs (they > were 4 years old with about 25k on them, but didn't look too bad when > I took them out). The wires are original. The car is a 99 with 47k > miles. > Your wires are seven years old. Time for new ones (OEM, of course). Old ones will leak current in damp weather, resulting in a weaker spark than what you should have, and worse combustion. Wires that are poor enough can cause hunting idle. Right now I suspect your problem has absolutely nothing to do with the IAC or the throttle body. -- TeGGeR® The Unofficial Honda/Acura FAQ www.tegger.com/hondafaq/ |
#5
|
|||
|
|||
Cleaning idle air control valve on 99 accord 4 cylinder
> At idle, full warm, you should be 750rpm in Drive. If you're around
> 1000rpm and fluctuating at that, I must ask these questions: Thanks for your help. More specifically, most of the time I can see the rpm gauge moving slightly up/down around 750. Other times, when I bring the car to a stop (hot in drive), the idle is closer to 1000 (no electrical or a/c load). > 1) When was the last time the cooling system was drained and refilled? The cooling system was drained/filled in March 06 by an independent shop that specializes in Hondas. > 2) How old is the thermostat? Original (7.5 years). > 3) What does the fluid look like when you pull the rad cap (cold!) It looks normal (green). > Your wires are seven years old. Time for new ones (OEM, of course). Old > ones will leak current in damp weather, resulting in a weaker spark than > what you should have, and worse combustion. Wires that are poor enough > can cause hunting idle. I thought I read here that Honda wires last a very long time. Anyway, the wire on cylinder 3 doesn't give me great tactile feedback (soft click) when I press it into place on the spark plug. I think it's engaged, but the others had a different feel when engaging. > Right now I suspect your problem has absolutely nothing to do with the > IAC or the throttle body. Other data points: the rotor and distributor cap were replaced 4 years ago. Last valve adjustment also 4 years ago. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OEM Honda parts catalogs for sale | Joe | Honda | 0 | March 26th 06 12:59 AM |
OEM Honda Parts Catalogs for Sale | Joe | Honda | 0 | March 12th 06 02:15 PM |
OEM Honda Microfiche parts catalogs for sale | Joe | Honda | 0 | March 4th 06 07:30 PM |
OEM Honda parts catalogs for sale | Joe | Honda | 0 | February 20th 06 11:44 PM |
OEM Honda Parts Catalogs for Sale | Joe | Honda | 0 | January 29th 06 05:24 PM |