If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ball Joints and Stuff
My TJ's got about 60+ K miles on it, many of them off road and it
looks, sounds, and feels like the ball joints are shot. When I replace them what else should I replace? The tire rod ends are beat, so they will be replaced, but what about hub bearings, u-joints, or anything inside the differential? And are there any brand name recommendations? I don't want to spend my time doing this and then have to do it again because I skimped on parts. A few extra bucks on top quality parts isn't going to break the bank and might save me some time in the future. Tia Dean |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1994 Accord EX - Front Suspension work | [email protected] | Honda | 19 | June 21st 06 02:26 AM |
E328i change ball joints | Franz Fripplfrappl | BMW | 6 | April 30th 06 07:13 AM |
1967 ball joint replacement | [email protected] | VW air cooled | 4 | October 16th 05 02:48 PM |
1997 Honda Civic: Axle and Lower Ball Joint Replacement Notes | Backpacker | Honda | 2 | November 18th 04 02:52 AM |