If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
93 Corvette Clutch issue
I'm really having a problem with both the pedal getting stiff and it not shifting as well. It seems to act exactly the opposite of common logic. It shifts the best after the car sits for a weekend and the pedal is the easiest to depress. As I drive the car I find the pedal tends to stiffen up. It's not a huge amount, but it is noticeable. If the fluid is boiling I could see it not shifting as well, but I would think the pedal would get easier to depress because it's getting spongy. On the other hand if my stiff pedal problem was related to the clutch pedal linkage, I wouldn't think it would change the shifting only how hard it is to depress. I did try the Valvoline Synthetic brake fluid, but went back to the GM clutch fluid because of the lubricating additives. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need help on repairing A/C clutch assembly ... replacement for missing pin? | [email protected] | Technology | 5 | August 10th 06 01:48 PM |
Question about repairing clutch plate on A/C ... pin needed | Greg Bailey | Technology | 0 | August 10th 06 12:28 AM |
squeaking clutch at friction point | sandheep | Mazda | 26 | February 17th 06 01:30 PM |
What now?? (Clutch slave again) | Eric | Jeep | 11 | May 29th 05 06:38 AM |