If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2003 Rubicon U-Joint Front Drive Shaft
Trying to replace the u-joint between the pinion yoke and the driveshaft.
The driveshaft yoke does not have spring clips, and it appears that the end-caps were pressed on. After some investigation, the end-caps are held in place by injected nylon. I used a torch to heat the yoke, then drove out the old u-joint. The problem is, I can't find the right replacement joint. The yoke has a groove for spring clips. Has anyone swapped one of these? I am thinking I should just get a new yoke that will take a 1310 u-joint. Paul Nelson |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
help! 95 XJ - growl at 40+ mph | paul | Jeep | 16 | July 26th 06 01:36 PM |
1992 lincoln with front wheel drive..air shock fix??? | shatt | Technology | 3 | January 10th 06 02:17 AM |
Front Drive Axle ('half shaft") replacement - 2001 Intrepid | Phil | Chrysler | 4 | January 1st 06 02:22 AM |
trouble changing CV joint ( half shaft) 93 Grand Caravan | The Stewarts | Chrysler | 2 | June 2nd 05 07:31 PM |
Reflections on a 350 mile test drive of a 2003 330i ZHP | nopcbs | BMW | 19 | December 10th 04 12:04 AM |