If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Chrysler Technicians : What is Chrysler spec MS-6395 ?
If any of the Chrysler Technicians reading this can find out, I would
like to know what Chrysler Material Spec MS-6395 actually says and specifies. I suspect it provides for lower volatility and possibly higher High Temp High Shear numbers ("HTHS")than the current API SM category provides, but I'm speculating. e-mail me off-line if appropriate. Even a lead as to whom I might contact about this would be good. Thanks....Phil |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 4 | May 23rd 06 05:24 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | April 7th 06 05:30 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 4 | October 19th 05 05:37 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | July 25th 05 05:29 AM |