If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
Just thinking about this option of hitting/shocking it - could you send
a shockwave trough the crank from the pully end ? or would that be a bad thing ! ? Rich Briantelope wrote: > In article >, > Speedy Jim > wrote: > > >>Not sure if this is physically possible, but if a thin steel >>wedge could be inserted into the gap, one could push it against >>the tranny shaft and then strike it with hammer blows. >>The resulting shock might very well break the rust gripping >>the splines on the clutch disc. > > > yeah, I kept thinking what the best way to break the hold would be. > that's a good idea, but the hard part is finding something thin enough, > but strong enough. > > Brian > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
engine stuck to tranny! ugh! | Briantelope | VW air cooled | 15 | March 7th 05 04:59 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 3 | February 18th 05 05:34 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 4 | February 2nd 05 05:22 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 18th 04 05:15 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | October 16th 04 05:28 AM |