If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
torqueing crank bolt
> any tricks to torque the crank bolt on a 95 w/o the special service tool?
> > thanks, > peter Put it in 5th gear, set parking brake, and loosen/lower the sway-bar. At least I had to on my 97, my torque wrench wouldn't fit in there unless I took the bolts almost all the way out and pulled the sway bar down as far as it would go. Chris |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
crank pulley bolt | peter | Mazda | 4 | June 10th 09 03:08 AM |
Crank Shaft Bolt (Which Way) | army guy | Honda | 13 | January 9th 06 03:25 AM |
crank bolt tightening debate | jim beam | Honda | 43 | November 30th 05 02:12 AM |
Crank bolt marked. | Burt S. | Honda | 2 | November 11th 05 03:22 AM |
stupid crank pulley bolt | disallow | Honda | 3 | October 6th 04 09:32 AM |