If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
cylinder head bolts
can ny 1 1 tell me what angle i need to turn my cylinder head bolts to
|
Ads |
#2
|
|||
|
|||
kitt2005 wrote: > can ny 1 1 tell me what angle i need to turn my cylinder head bolts to turn m >>>>> |
#3
|
|||
|
|||
Right.....
Should we use a crystal ball or cards? Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's kitt2005 wrote: > > can ny 1 1 tell me what angle i need to turn my cylinder head bolts to |
#4
|
|||
|
|||
kitt2005 wrote: > can ny 1 1 tell me what angle i need to turn my cylinder head bolts to 200 ft-lbs and then an extra half turn, in two quarter turn steps. seriously, year, make, model, engine would help... nate |
#5
|
|||
|
|||
1000cc 1986
|
#6
|
|||
|
|||
nissan micra 1000cc 1986
|
#7
|
|||
|
|||
what's the outer (OD) diameter of a head bolt?
-- Remove *flaps* to reply "kitt2005" > wrote in message lkaboutautos.com... > 1000cc 1986 > |
#8
|
|||
|
|||
Keep turning till they turn easier. ;-)
kitt2005 wrote: > can ny 1 1 tell me what angle i need to turn my cylinder head bolts to > |
#9
|
|||
|
|||
In article outautos.com>,
says... >can ny 1 1 tell me what angle i need to turn my cylinder head bolts to Yes. ------------ Alex |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1.5 civic non vtec cylinder head gasket questions. | Gerry | Honda | 4 | February 28th 05 05:26 AM |
Taking pictures of a cylinder without removing the head? | Dennis | Technology | 3 | February 6th 05 01:30 PM |
96 Nissan Sentra... Bolts off but I can't get head off.... | Al Kondo | Technology | 3 | January 7th 05 12:28 AM |
Dodge 2.5L eats another head (and how long is the bottom end good for) | Bob Fourney | Dodge | 6 | August 28th 04 01:07 AM |