If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Radio
I need instructions for installing a stock radio in a 1990 Plymouth
Sundance. On my first try it seemed as though the entire dashboard must be removed. Help would be appreciated. Arnold |
Ads |
#2
|
|||
|
|||
Radio
adoom wrote: > I need instructions for installing a stock radio in a 1990 Plymouth > Sundance. On my first try it seemed as though the entire dashboard must > be removed. Help would be appreciated. > > Arnold On most Chrysler products of that era, just the panel around the radio needs to be removed. It is removed by gently pulling around the edges until the snaps pop out. Once it is loose, the ash try lamp will need to be removed from it's holder on the bottom of the panel. I am not sure if the Sundance has one or not. Once the panel is removed, there will be two hex screws that hold the radio in. Does your Sundance already have a radio installed? I believe that even base models at least came with the AM/FM Stereo radio. If you are installing a stock radio, you will just need to connect the black and grey connectors to the back, the antenna, and the ground strap. -KM |
#3
|
|||
|
|||
Radio
KM
Thanks for the help. I was afraid to pry on the plastic panel around the radio and heater. I will give it a try ever so gentle.I let you know. Arnold |
#4
|
|||
|
|||
Radio
ATTN: KM
It worked, just as you said. Problem is the replacement radio won't turn on either. Must be something in the wiring. Fuse is good. Any helpful tips trying to trace the wires? Arnold |
#5
|
|||
|
|||
Radio
adoom wrote: > ATTN: KM > > It worked, just as you said. Problem is the replacement radio won't > turn on either. Must be something in the wiring. Fuse is good. Any > helpful tips trying to trace the wires? > > Arnold I am afraid that I can't help much there. A wiring diagram would probably be best if you can find one for that model. Should be included in the factory service manual. As a start, you might check the harness connectors to ensure that they are making good contact. Is the LED clock on the radio face displaying? If not, neither power conductor to the radio is getter power. -KM |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
'98 F-150 radio plug wire colors? | Steve | Technology | 1 | March 5th 06 03:10 PM |
'06 Mustang Colors, Part II | Ken Zwyers | Ford Mustang | 37 | February 11th 06 04:45 AM |
Audi Radio: Delta CC in 96 Audi Cab doesn't turn on...... | [email protected] | Audi | 4 | March 19th 05 01:28 PM |
2004 TJ Radio Removal? | Intergate | Jeep | 2 | February 10th 05 01:52 AM |
On-board Radio Diagnostic | Oppie | Saturn | 0 | August 23rd 04 02:39 AM |