If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
WTB: Crank shaft + #4 Bearing Cap for 270 Red Ram Hemi
Title says it all.
Any advice on a source or sources would be much appreciated as well. Thanks, p |
Ads |
#2
|
|||
|
|||
WTB: Crank shaft + #4 Bearing Cap for 270 Red Ram Hemi
On Mon, 11 Sep 2006 17:45:15 -0400, "pawn" >
wrote: >Title says it all. > >Any advice on a source or sources would be much appreciated as well. <snip> Lots of luck on that! '56 New Yawkah, or '57-'58 Windsor? |
#3
|
|||
|
|||
WTB: Crank shaft + #4 Bearing Cap for 270 Red Ram Hemi
pawn wrote: > Title says it all. > > Any advice on a source or sources would be much appreciated as well. > > Thanks, > > p There is an early Dodge hemi in a junkyard here, I can get you the entire engine, but it won't be cheap. It is seized most likely, but you can salvage the crankshaft. Early Dodge hemis were known to break crankshafts- is yours broken or just worn ?? They are forged steel, so you have them welded up and reground. You can also try this link- but they may only cater to the larger Chrysler hemi http://www.earlyhemiengineparts.com/ |
#4
|
|||
|
|||
WTB: Crank shaft + #4 Bearing Cap for 270 Red Ram Hemi
DeserTBoB wrote: > On Mon, 11 Sep 2006 17:45:15 -0400, "pawn" > > wrote: > > >Title says it all. > > > >Any advice on a source or sources would be much appreciated as well. <snip> > > Lots of luck on that! '56 New Yawkah, or '57-'58 Windsor? You DUMB ASS, he said Dodge Red Ram- the big Chrysler cars you mention had the larger 331-354-392 Chrysler Hemi- not the small Dodge 270 hemi. What did you do, get an old repair manual and start rattling off names from it ? It's pretty obvious you are quoting and reading from repair manuals, Boob... |
#5
|
|||
|
|||
WTB: Crank shaft + #4 Bearing Cap for 270 Red Ram Hemi
duty-honor-country wrote: > DeserTBoB wrote: > > On Mon, 11 Sep 2006 17:45:15 -0400, "pawn" > > > wrote: > > > > >Title says it all. > > > > > >Any advice on a source or sources would be much appreciated as well. <snip> > > > > Lots of luck on that! '56 New Yawkah, or '57-'58 Windsor? > > > You DUMB ASS, he said Dodge Red Ram- the big Chrysler cars you mention > had the larger 331-354-392 Chrysler Hemi- not the small Dodge 270 hemi. > What did you do, get an old repair manual and start rattling off names > from it ? > > It's pretty obvious you are quoting and reading from repair manuals, > Boob... It's pretty obvious you are following Bob...again. |
#6
|
|||
|
|||
WTB: Crank shaft + #4 Bearing Cap for 270 Red Ram Hemi
On 12 Sep 2006 03:57:28 -0700, "duty-honor-country"
> wrote: >There is an early Dodge hemi in a junkyard here, I can get you the >entire engine, but it won't be cheap. It is seized most likely, but >you can salvage the crankshaft. Early Dodge hemis were known to break >crankshafts- is yours broken or just worn ?? <snip> Do NOT deal with this huckster and fraudster. He's 1.) a bull**** artist, and 2.) has a long history of ripoffs on eBay. Caveat emptor. |
#7
|
|||
|
|||
WTB: Crank shaft + #4 Bearing Cap for 270 Red Ram Hemi
On 12 Sep 2006 04:04:47 -0700, "duty-honor-country"
> wrote: >You DUMB ASS, he said Dodge Red Ram- <snip> No, he didn't...moron. He specifically said a 354, which was in the '56 New Yorker, and the '57-'58 Windsor and other models. You can't even read, can you....Noodles? |
#8
|
|||
|
|||
WTB: Crank shaft + #4 Bearing Cap for 270 Red Ram Hemi
On 12 Sep 2006 05:36:38 -0700, "bicycle, The Fifth Wheel King"
> wrote: >It's pretty obvious you are following Bob...again. <snip> The Social Security money must already be spent and money's getting tight. |
#9
|
|||
|
|||
WTB: Crank shaft + #4 Bearing Cap for 270 Red Ram Hemi
DeserTBoB wrote: > On 12 Sep 2006 03:57:28 -0700, "duty-honor-country" > > wrote: > > >There is an early Dodge hemi in a junkyard here, I can get you the > >entire engine, but it won't be cheap. It is seized most likely, but > >you can salvage the crankshaft. Early Dodge hemis were known to break > >crankshafts- is yours broken or just worn ?? <snip> > > Do NOT deal with this huckster and fraudster. He's 1.) a bull**** > artist, and 2.) has a long history of ripoffs on eBay. > > Caveat emptor. Funny how the last vehicle he "sold" on ebay never had any feedback. He bid on it himself with a fake account to save face because it wouldn't sell. |
#10
|
|||
|
|||
WTB: Crank shaft + #4 Bearing Cap for 270 Red Ram Hemi
On 12 Sep 2006 04:04:47 -0700, "duty-honor-country"
> wrote: >You DUMB ASS, he said Dodge Red Ram- the big Chrysler cars you mention >had the larger 331-354-392 Chrysler Hemi- not the small Dodge 270 hemi. > What did you do, get an old repair manual and start rattling off names >from it ? <snip> Noodles was right here....the 270 RR is exactly the same engine in the CUSTOM Royal Lancer here in town...which I'm going to help get running again. But he wants other parts, such as head bolts and pushrods, for the Chrysler 354, which was in the models I stated. Obviously, he's got two hemis he's working on. Pawn, check my earlier post under "found in barn, complete" about a '55 Custom Royal Lancer I found out here and drool! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tail shaft bearing replacement part 2 | Carl | Ford Mustang | 2 | March 8th 06 04:15 AM |
Crank Shaft Bolt (Which Way) | army guy | Honda | 13 | January 9th 06 03:25 AM |
Right Rear Axle Shaft Bearing Questions '88 XJ Dana 35 | dave AKA vwdoc1 | Jeep | 4 | August 4th 05 11:15 PM |
endplay problem | Robert Rutler | VW air cooled | 24 | March 15th 05 09:57 PM |
scirocco steering shaft bearing | nutso fasst | VW water cooled | 4 | December 29th 04 02:14 AM |