![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
My jeep ( 01 TJ) is set up with a 4 inch pro comp short arm kit, and 33's...
How much trimming would I have to do to get 35's to fit with reasonable room for flex? And what am I supposed to be cutting on? I don't mind chopping it up a bit. I've seen some front fenders trimmed to look like flatfenders, and the rear cut into pretty good also. Anyone know where I can find some more info? Troy |
Ads |
#2
|
|||
|
|||
![]()
Trial & error, I did a CJ5 to a flat fender that I liked. Didn't do rear
because I lifted body 2" "Troy" <troy@ .> wrote in message ... > My jeep ( 01 TJ) is set up with a 4 inch pro comp short arm kit, and > 33's... > How much trimming would I have to do to get 35's to fit with reasonable > room for flex? > And what am I supposed to be cutting on? I don't mind chopping it up a > bit. I've seen some front fenders trimmed to look like flatfenders, and > the rear cut into pretty good also. Anyone know where I can find some > more info? > > Troy > |
#3
|
|||
|
|||
![]()
Troy,
Hit any of the jeep forums online and search for "flat fender". Heck a google search pulls some decent results, too. The end result of cutting the the rear end is sometimes called "competition corners". Once you find what you're looking for, draw a line and put a cutting tool to it. Yes, it's that easy : ) n. "Troy" <troy@ .> wrote in message ... > My jeep ( 01 TJ) is set up with a 4 inch pro comp short arm kit, and > 33's... > How much trimming would I have to do to get 35's to fit with reasonable > room for flex? > And what am I supposed to be cutting on? I don't mind chopping it up a > bit. I've seen some front fenders trimmed to look like flatfenders, and > the rear cut into pretty good also. Anyone know where I can find some > more info? > > Troy > |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Smittybilt Tube Fenders | Jeff | Jeep | 7 | April 1st 05 10:29 PM |
Wrangler fenders | Chris Ryder via CarKB.com | Technology | 2 | March 27th 05 07:21 PM |
Wider Fenders | TerryB | VW air cooled | 10 | March 8th 05 05:29 PM |
any way to protect NOS fenders? | Nate Nagel | Antique cars | 16 | October 24th 04 12:40 PM |
20's-30's fenders | Glenn Pavlovic | Antique cars | 1 | October 29th 03 01:59 AM |