|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
August 24th 06, 12:47 AM
posted to rec.autos.makers.jeep+willys
|
|||
|
|||
CAN protocol?
My '97 ZJ (grand cherokee) has a stamp in the engine bay that reads "Made in
Cananda". Does this mean that it has a CAN protocol regarding a OBDII scanner? I'm looking to purchase a scanner, and don't want to buy the wrong one. Thanks 
|
|
#2
August 24th 06, 06:51 AM
posted to rec.autos.makers.jeep+willys
|
|||
|
|||
|
CAN protocol?
I can't believe the Environmental Protection Agency that requires
On-Board Diagnostics II being anything other than an a Bleeding heart liberal wacko greenie limp's screw up: therefore there would only be an American standard. God Bless America, Bill O|||||||O http://www.billhughes.com/ Abby Normal wrote: > > My '97 ZJ (grand cherokee) has a stamp in the engine bay that reads "Made in > Cananda". Does this mean that it has a CAN protocol regarding a OBDII > scanner? I'm looking to purchase a scanner, and don't want to buy the wrong > one. > > Thanks
|
|
#3
August 24th 06, 11:00 AM
posted to rec.autos.makers.jeep+willys
|
|||
|
|||
|
CAN protocol?
A scanner is a scanner is a scanner
Coasty "L.W.(Bill) Hughes III" > wrote in message ... > I can't believe the Environmental Protection Agency that requires > On-Board Diagnostics II being anything other than an a Bleeding heart > liberal wacko greenie limp's screw up: therefore there would only be an > American standard. > God Bless America, Bill O|||||||O > http://www.billhughes.com/ > > Abby Normal wrote: >> >> My '97 ZJ (grand cherokee) has a stamp in the engine bay that reads "Made >> in >> Cananda". Does this mean that it has a CAN protocol regarding a OBDII >> scanner? I'm looking to purchase a scanner, and don't want to buy the >> wrong >> one. >> >> Thanks
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What is the protocol to obtain misfire data on cylinders for a '99 Cad Deville? | Rich | Technology | 3 | December 20th 05 09:47 PM |
| BMW 20 pin to DB9 cable for E36 - Pin Out | Karl J. North III | BMW | 3 | May 2nd 05 02:25 AM |
Hybrid Mode
