If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
update on '92 stuck mirrors
Hi,
A long time ago I posted here asking about how to fix my mirrors that wouldn't budge. I was given advice on how to proceed and here's what happened. I started with the passenger side. By sticking a screwdriver in a small slot at the base of the housing the housing popped off its retainer plate, and allowed me to rotate it revealing two bolts that hold the mirror to the car door. Removal was that simple. The metal inside the mirror was rusted and there was a lot of corrosion. That's why the mirror was stuck. I put the mirror upside down on the work bench and spent a week pouring PB Blaster into the metal parts but it didn't free it up. Then I reversed it and put the oil in under the mirror and let gravity pull it down onto the metal parts inside of the mirror. This didn't work either, so eventually I took a socket wrench and just went for it. This resulted in snapping the bolt that held the mirror parts together where all of the corrosion was located. To get to the inside of the mirror I took off the black plastic retainer that snaps onto the rim of the housing that holds the mirror. With that off I could pry the mirror out of the housing and see what was going on inside. I removed all the metal and cleaned it up on a bench mounted wire wheel. I had a stainless bolt of about the right length, though it was 2mm too thin, and used that and reassembled the mirror. It's a bit on the loose side, but it works. Because I then knew exactly where the metal parts inside the mirror were, I was able, on the driver side, to shot PB Blaster into the housing with the mirror on the car. I did this every other day for a couple of weeks and got lucky. It freed up and now it works. This may have worked on the passenger side had I known how it was put together in the first place. One caution: My car is white and the penetrating oil is orange and stained the white paint so be careful that way if you try this. I've used many different penetrating oils over the years and so far PB Blaster is what has worked the best. Alic |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
bug mirrors | [email protected] | VW air cooled | 3 | March 30th 07 03:26 AM |
blinker stuck on- update- 99 jeep cherokee classic | jczap | Chrysler | 2 | September 8th 06 12:57 AM |
blinker stuck on- update- 99 jeep cherokee classic | jczap | Chrysler | 0 | September 7th 06 06:59 PM |
outside mirrors | BDragon | Corvette | 0 | May 31st 06 08:26 AM |
help with m3 mirrors, please!!!!!! | j jonusaite | Audi | 3 | August 4th 04 02:16 AM |