|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
Pond sealer/plants dead
A few months ago we applied a 'pond sealer' as our concrete based pond had
sprung a leak.
Since then all has been fine with the fish & no leaking. They have even
spawned & we have young goldfish (fanatails & shebunkins) thriving in a
All the plants that we had previously were vigorous & needed constant
cutting back but have now died.
I went to a bit of expense & got new ones - same thing happened.
I could see no warning on the can & we followed directions to the letter re
changing the water etc., before re-introducing the fish again.
Is there anything we can do as we live in a hot climate & the fish need
protection from the heat. We do have shadecloth over the pond but would also
like some plants to survive.
Anyone got any ideas please?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Please Critique This Pond Advice||[email protected]||General||4||May 5th 06 02:56 AM|
|Poor dead mouse in pond???||Ann505||General||6||August 16th 05 05:22 PM|
|Pond in planning stages||Gill Passman||General||34||May 21st 05 12:37 AM|
|The 'Aquascape System' has the be the WORST pond system outthere||Glenn||General||11||November 17th 03 10:58 PM|
|Problems with my pond?||Thenewguy||General||12||August 25th 03 09:42 PM|