If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HELP w/ placement of headliner fasteners
I just had a new headliner put in, but instead of the original four push-pin
fasteners along the back edge the shop only put the two middle fasteners back in place. Where the missing two fasteners on either side used to be is now covered over with new headliner material. How do I find the correct position to replace the missing fasteners? Is it safe enough for a do-it-yourselfer to do? |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
no lube on auto fasteners? | [email protected] | Technology | 77 | January 13th 05 03:10 PM |
Placement of a temp sensor | John Smith | Honda | 3 | November 3rd 04 03:37 AM |
Where to buy a headliner | Doggus | Saturn | 4 | July 4th 04 04:13 AM |
Saturn headliner installation | Doggus | Saturn | 1 | June 21st 04 03:28 AM |
Headliner | Barry Schnoor | Saturn | 1 | June 18th 04 02:43 AM |