If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Half Shaft Nut
I have an e36 318i '94. The nut on the half shaft which locates the hub on
my car keeps undoing? I have used new nuts and torqued to 200Nm, used thread lock, and hammered over the castelated part of the nut. What would be causing this? Any ideas? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help, AWD, Tranfer case / front drive shaft question...... | No Email Address | Ford Explorer | 3 | June 19th 05 02:18 AM |
Left Transaxle Shaft Seal | Doug Samuel | Chrysler | 7 | June 3rd 05 12:59 PM |
trouble changing CV joint ( half shaft) 93 Grand Caravan | The Stewarts | Chrysler | 2 | June 2nd 05 07:31 PM |
Off topic, tractor pto shaft | [email protected] | Technology | 9 | April 22nd 05 09:59 AM |
Noise after lift, 97TJ, bump stop shaft & spring? | pbarton | Jeep | 8 | January 9th 05 09:16 PM |