If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Loose caliper on Integra?
95 Teg LS....
Did a complete brake job, including two new rear calipers (old ones were binding up pretty good). About a month after I finished the job, I'm hearing a pretty loud knocking from the rear when going slow over bumps. Noise goes away when I depress brake pedal or pull on e-brake handle a few clicks. So I dive underneath and start pulling on things to see what's loose. Get to the calipers and when I pulled on them by the brake hose boss and giggle, they deflect a good 1/8 -1/4 of an inch back and forth! That's not right, is it? No car I've ever worked on had their calipers move at all, even when retracted. I'm thinking the rebuilder did a lousy job and used wrong hardware...surprising ,but I guess possible. Thoughts? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heater boxes loose casing | Fred | VW air cooled | 1 | April 6th 05 12:35 AM |
Reassembly of caliper, to much pressure on outside rotor | Vince | Technology | 6 | January 10th 05 10:56 PM |
98 accord rear brake caliper | John Edwards | Technology | 4 | January 4th 05 03:19 AM |
stuck caliper... | Abeness | Honda | 113 | December 7th 04 01:22 AM |