|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
October 26th 04, 10:59 AM
|
|||
|
|||
Kevin wrote:
> Bill- > Thanks for the advice... I was able to do the task without removing > the hub... found a spot where I had enough clearance to get the new > ones in so I pounded out the old and installed the new... -Kevin You're welcome - glad you got it fixed. Bill Putney (To reply by e-mail, replace the last letter of the alphabet in my adddress with the letter 'x') ----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==---- http://www.newsfeeds.com The #1 Newsgroup Service in the World! >100,000 Newsgroups ---= East/West-Coast Server Farms - Total Privacy via Encryption =--- 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New *FREE* Corvette Discussion Forum | JLA ENTERPRISES TECHNOLOGIES INTEGRATION | Corvette | 12 | November 30th 04 06:36 PM |
| 1976 Front Wheel Bearing | coffee01 | Corvette | 4 | November 2nd 04 05:06 PM |
| Jack lift point on front of Voyager | retiredusarmy | Chrysler | 8 | October 17th 04 12:14 PM |
| A4 - Front Wheel Bearings ? | Graeme | Audi | 1 | July 15th 04 12:47 PM |
Threaded Mode