door sticker fell off

this si a lame question, but the sticker on the inside of my drivers side
door is falling off, the one that shows the VIN number etc..what can I
properly reattach it with ? TIA

--
marx404

I used two-tube epoxy (the stuff that comes in two separate tubes - you
mix them together) to reattach my driver-side rearview mirror. The
mirror has since survived multiple trips through the car wash - I
imagine that the same stuff will hold the sticker on just fine.

Good luck,

Ted
1996 Black-Gold SC2

marx404 wrote:
> this si a lame question, but the sticker on the inside of my drivers side
> door is falling off, the one that shows the VIN number etc..what can I
> properly reattach it with ? TIA
>
> --
> marx404

"marx404" > wrote in message
...
> this si a lame question, but the sticker on the inside of my drivers side
> door is falling off, the one that shows the VIN number etc..what can I
> properly reattach it with ? TIA
>
> --
> marx404
>
>
>
3M Trim Adhesive might work.

Ken

thanks, I should add that it split in half, the clear part separated from
the white backing, I must use something clear or I wont be able to read the
sticker.

marx404

"marx404" > wrote in message
...
> thanks, I should add that it split in half, the clear part separated from
> the white backing, I must use something clear or I wont be able to read
> the
> sticker.
>
> marx404
>
>

Could you use a piece of the plastic used to laminate paper ID cards?

Ken