If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
camber
I just rebuilt the front end of my 2000 xls 4WD 4.0L. I replaced the
shocks, ball joints, wheel bearings, end links and an inner tie rod. I also raised the front by about a 1/4 inch via the torsion bars. When I went to get a alignment they told me the right side camber was off by -1. he told me that a camber kit for the right side was sold. I have looked online for this kit with no luck. Has any one ever heard of this kit and know where to buy it. I have only found the replacement camber caster kit that are for the left side. Any help would be great. Thank you |
Ads |
#2
|
|||
|
|||
camber
Ford offers alignment cams for this application.... the upper control arm
bolts should already have the eccentric on them making only the eccentric washers required.... Specialty Products also sells these parts and have two kits available for this application.... One is just the eccentric washers and the other is both bolts and washers.... Their catalog can be accessed through http://www.specprod.com/ "mab6680" > wrote in message lkaboutautos.com... >I just rebuilt the front end of my 2000 xls 4WD 4.0L. I replaced the > shocks, ball joints, wheel bearings, end links and an inner tie rod. I > also raised the front by about a 1/4 inch via the torsion bars. When I > went to get a alignment they told me the right side camber was off by -1. > he told me that a camber kit for the right side was sold. I have looked > online for this kit with no luck. Has any one ever heard of this kit and > know where to buy it. I have only found the replacement camber caster kit > that are for the left side. Any help would be great. Thank you > |
#3
|
|||
|
|||
camber
I found the camber kit at my local parts store today. They had both of
these kits your talking about. I went with the kit that came with the bolts and washers. the kit was made by moog. Thank you for your reply |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
98' Accord, Rear camber not adjustable? The followup. | Al[_1_] | Honda | 1 | July 26th 06 12:31 PM |
70 mustang camber adjustment | [email protected] | Ford Mustang | 1 | July 22nd 06 08:57 PM |
E34 Camber adjustment | [email protected] | BMW | 1 | July 3rd 06 01:56 PM |
Camber again | ThaDriver | VW air cooled | 3 | December 13th 04 10:51 AM |
Wheel Camber | Mel P. | VW air cooled | 6 | November 6th 04 06:05 PM |