If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
wheel question for Lanny
Lanny,
what diameter and width wheel are you running with the 205/50 series RE-11's? Thanks, Pat |
Ads |
#2
|
|||
|
|||
wheel question for Lanny
In article >,
pws > wrote: > what diameter and width wheel are you running with the 205/50 series > RE-11's? 15x6.5, and they seem to work just fine. -- Lanny Chambers St. Louis, MO '94C |
#3
|
|||
|
|||
wheel question for Lanny
Lanny Chambers wrote:
> In article >, > pws > wrote: > >> what diameter and width wheel are you running with the 205/50 series >> RE-11's? > > 15x6.5, and they seem to work just fine. Thanks. I was discussing tire sizes with some other people and one person was wondering about going with 205/50/15's on a 6" rim, so I was checking to see if you had done that, or as I suspected, you had gone with a slightly wider wheel to match the 205 series tires. Pat |
#4
|
|||
|
|||
wheel question for Lanny
In article >,
pws > wrote: > I was discussing tire sizes with some other people and one > person was wondering about going with 205/50/15's on a 6" rim, so I was > checking to see if you had done that, or as I suspected, you had gone > with a slightly wider wheel to match the 205 series tires. Well, those are the aftermarket wheels that have been on the car for years. Before ordering 205s, I did check the specs: the recommended range is 5.5-7.5, and the specs were measured on a 6.5 wheel. -- Lanny Chambers St. Louis, MO '94C |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Lanny - Alignment settings on a Honda Accord - NMC | pws[_1_] | Mazda | 4 | October 3rd 09 06:41 AM |
Hey Lanny | Iva | Mazda | 2 | April 17th 08 03:21 PM |
Question: Regarding wheel offset and WTB: 1995 Jetta III steel wheel | Timothy J. Richter | VW water cooled | 4 | March 10th 07 03:51 PM |
NC wheel question | Chris D'Agnolo | Mazda | 1 | June 7th 06 06:01 AM |
Bearing Races Question and Wheel Bearing Pack Question | Kevin Holzer | VW air cooled | 3 | June 11th 05 05:51 AM |