If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
endplay on crank
1600 dual port
idiots guide says to adjust endplay to .004", install paper gasket (.009" thick) and torque flywheel on. This would put .005" tension on crankshaft. I measured endplay. I have .009" is it vital to adjust to .004? Jen |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1.8 Miata Crank Angle Sensor | Marty | Mazda | 5 | March 18th 05 03:44 PM |
Help Crank Position Sensor for 89 Cherokee LTD | L.W.(ßill) Hughes III | Jeep | 17 | February 8th 05 07:35 AM |
Crank and Camshaft Sensor Replacement? | Guess Who I Am | Chrysler | 6 | December 4th 04 11:05 AM |
Mopar Crank Handle | Steve | Antique cars | 0 | August 14th 04 10:53 PM |