If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
fuel pressure gauge?
i am in the process of putting a ATI procharger on a 87, it shipped
today. i want some instrumentation for the car, i have purchased a "innovate" LM-1, LMA-3, and the Gauge that goes with this wide band air/fuel ratio meter, also i have Autometer boost and electric fuel pressure gauges. The question is does any one make a adaptor that will screw on to the stock fuel pressure test port that i can convert to 1/8 NPT? i am not having much luck finding anything. you would think as many TPI motor as there are out there some one would make one. if not i guess it is off to the machine shop. thanks, Greg |
Ads |
#2
|
|||
|
|||
nobody has put a fuel pressure gauge on a tpi motor?
On Mon, 13 Jun 2005 18:08:08 GMT, Greg > wrote: >i am in the process of putting a ATI procharger on a 87, it shipped >today. i want some instrumentation for the car, i have purchased a >"innovate" LM-1, LMA-3, and the Gauge that goes with this wide band >air/fuel ratio meter, also i have Autometer boost and electric fuel >pressure gauges. The question is does any one make a adaptor that will >screw on to the stock fuel pressure test port that i can convert to >1/8 NPT? i am not having much luck finding anything. you would think >as many TPI motor as there are out there some one would make one. >if not i guess it is off to the machine shop. thanks, Greg |
#3
|
|||
|
|||
Machine shop should have my adaptor done by Tuesday, the thread size
where it goes into the fuel log is 5/16-18 and will seal with a flat seal ring with a rubber o-ring made to it, making it out of stainless (308) it will have a hex head and then will neck up to a AN -04 male. i still can not belive that no one makes something like that. Greg On Mon, 13 Jun 2005 18:08:08 GMT, Greg > wrote: >i am in the process of putting a ATI procharger on a 87, it shipped >today. i want some instrumentation for the car, i have purchased a >"innovate" LM-1, LMA-3, and the Gauge that goes with this wide band >air/fuel ratio meter, also i have Autometer boost and electric fuel >pressure gauges. The question is does any one make a adaptor that will >screw on to the stock fuel pressure test port that i can convert to >1/8 NPT? i am not having much luck finding anything. you would think >as many TPI motor as there are out there some one would make one. >if not i guess it is off to the machine shop. thanks, Greg |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
warman i am surprised you mix oil | [email protected] | Ford Mustang | 5 | May 8th 05 04:04 AM |
DaimlerChrysler Commits Over $70 Million to Fuel Cell | Shrike | Dodge | 0 | March 30th 05 09:03 PM |
Oil pressure gauge sticking on start-up in cold weather? | Azfreeflyer | Ford Explorer | 6 | December 27th 04 03:22 PM |
'99 Explorer Fuel pressure problem | Tim South | Ford Explorer | 2 | December 20th 04 05:49 PM |
76 Difficult Cold Starts | daveo76 | Corvette | 22 | September 9th 04 12:54 AM |