If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#22
|
|||
|
|||
On Mon, 3 Jan 2005 21:18:40 -0600, DougW wrote:
>> But the inside seemed really smashed. It's hard to see in this pic because >> I had a hard time maneuvering the camera in there. >> >> http://www.mwjtc.com/jeep/sway-mount2.jpg > > That's "normal" wear due to the bars curvature at that point. > > Little bit of rust there. Might want to rework the bar > (sand and paint) And make sure that's raggedy looking line > isn't a crack (unlikely, but...) The crack is just in the paint. It's coated in some really thick paint that comes off in sheets when you so much as touch it. Any special paint to use? Just some black rustoleum spray paint? Thanks -- becker; email = remove the fruit; |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Front suspension "clunk" '94 Concorde | Dave A. | Chrysler | 16 | December 18th 04 03:59 PM |
Front suspension Clunk??? | Chris | Audi | 3 | October 29th 04 08:17 PM |