If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
3057NA 3157NA 3357NAK 3457NAK etc
On Wed, 23 Mar 2005, David Cole wrote:
> What is the difference between all these bulbs? NA = Natural Amber, the glass is actualy amber. Used to be made with Cadmium, upon which there are now restrictions for environmental reasons (it's a toxic heavy metal that's difficult to dispose of safely). Non-Cad amber glass is available but very expensive, so most amber bulbs are now "painted" (dip coated) in a transparent amber gookum. Some gookums are much better than others -- off colors, burn/fade, etc. Some marketers call the coated bulbs "A" (as in 3157A) to differentiate them from the "NA" bulbs; other makers are retaining the "NA" numbers for the dipped bulbs. (20 years ago, "A" indicated a bulb that was literally painted school bus yellow. You could not see the filament through the yellow paint, which scratched off easily. Nobody sells these any more.) "K" = Krypton, a gas that can be added to the fill mix to improve bulb life without reducing bulb output. Some makers use "LL" instead of "K" (So, for instance, 3157K and 3157LL can be considered equivalent to one another). Now, output listed bright/dim: 3057: 32/2 candlepower (also 3057K, 3057LL) 3057A: Amber version (also 3057NA, 3057NA/K, 3057NA/LL...) 3157: 32/3 candlepower (3157K, 3157LL) 3157A: Amber version (3157NA, NA/K, NA/LL...) 3357: 40/3 candlepower (3357K, LL...) 3357A: Amber version (NA, NA/K, NA/LL...) 3457: 40/3 candlepower, high-heat base (K, LL...) 3457A: Amber version (NA, NA/K, NA/LL...) 4157: 32/3 candlepower extra long life (K, LL) 4157A: Amber version (NA, NA/K, NA/LL...) 4114: 32/3 candlepower ultra long life (K, LL) 5702KA: Amber version The last two bulbs on the list exist because of GM's stupidity. GM voltage regulator set points have been creeping steadily upward for decades and are now at around 15.4v, which is causing GM bulbs to fail early and often, especially those bulbs that are always on. The 4114 was devised as an ultra long life replacement for 3157/4157 in GM's trucks and SUVs with white DRLs, while 5702KA is the amber version for GM's vans and cars with turn signal DRLs. At the moment these bulbs are available only from GM dealers (to get 4114, ask for a daytime running light bulb for a 2003 Chevrolet 1500 pickup or a 2004 Chevrolet Express van; to get 5702KA ask for a park/turn/daytime running bulb for a 2004 Saturn Ion). The 5702KA is a very good long-term fix for any vehicle with turn signal DRLs ('96-'00 Chrysler minivans in Canada, '01-up PT Cruiser in Canada, early Mazda Miata, etc.) As a final note, do not be tempted to replace a 3057 (32/2cp) with a 3157 (32/3cp). Doing so will increase the taillamp intensity by 50%, which by itself might not be a bad thing, but which will interfere with the bright/dim intensity ratio, making it harder to discern your brake lights from your taillights, or your turn signals from your parkers if used up front. If for some reason you need to increase the intensity of the dim mode (park or tail) originally equipped with a 3057, then use one of the 40/3cp bulbs, but be careful to make sure the bright mode (brake or turn) isn't glaringly bright. DS |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3057NA 3157NA 3357NAK 3457NAK etc | David Cole | Chrysler | 1 | March 24th 05 01:43 AM |