If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Car shaking after changing spark plugs
Hi,
Today I replaced the six spark plugs of my 94 Ford Taurus. However, when I stop for red lights, the car shakes every one or two seconds. Does anybody know the reason? Could it be that I didn't adjust the gap? Thanks, Wei |
Ads |
#2
|
|||
|
|||
Car shaking after changing spark plugs
One wire is not plugged in properly or the wires are in the wrong order or
you cracked a plug during the installation. "Wei Hu" > wrote in message oups.com... > Hi, > > Today I replaced the six spark plugs of my 94 Ford Taurus. > However, when I stop for red lights, the car shakes every one or two > seconds. > Does anybody know the reason? > Could it be that I didn't adjust the gap? > > Thanks, > Wei > ----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==---- http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups ----= East and West-Coast Server Farms - Total Privacy via Encryption =---- |
#3
|
|||
|
|||
Car shaking after changing spark plugs
Wei Hu wrote:
> > Hi, > > Today I replaced the six spark plugs of my 94 Ford Taurus. > However, when I stop for red lights, the car shakes every one or two > seconds. > Does anybody know the reason? > Could it be that I didn't adjust the gap? > > Thanks, > Wei Add to what Shep said: Possibly destroyed a wire or several while changing plugs. |
#4
|
|||
|
|||
Car shaking after changing spark plugs
On 26 Aug 2006 16:41:00 -0700, "Wei Hu" > wrote:
>Hi, > >Today I replaced the six spark plugs of my 94 Ford Taurus. >However, when I stop for red lights, the car shakes every one or two >seconds. >Does anybody know the reason? >Could it be that I didn't adjust the gap? Your car will miss at idle if the spark plug gaps are too close. Also, if you put in Bosch take them out. Don www.donsautomotive.com > >Thanks, >Wei |
#5
|
|||
|
|||
Car shaking after changing spark plugs
Wei Hu Wrote: > Hi, > > Today I replaced the six spark plugs of my 94 Ford Taurus. > However, when I stop for red lights, the car shakes every one or two > seconds. > Does anybody know the reason? > Could it be that I didn't adjust the gap? > > Thanks, > Wei I'll cocurr with the others...cracked insulator or damaged plug wire most likely, gap not so much so, but possible...if they were platinum plugs with the preset gap, they are rarely ever wrong...the electrode is tough as hell and doesn't bend easily.. I agree also, Bosch Plats are crap, I'd throw them away if that's what you got, get Motorcraft or Autolite for it... -- jeffcoslacker ------------------------------------------------------------------------ jeffcoslacker's Profile: http://www.automotiveforums.com/vbul...?userid=219638 View this thread: http://www.automotiveforums.com/vbul...d.php?t=611307 http://www.automotiveforums.com |
#6
|
|||
|
|||
Car shaking after changing spark plugs
jeffcoslacker > wrote in article >... > > > I'll cocurr with the others...cracked insulator or damaged plug wire > most likely, gap not so much so, but possible...if they were platinum > plugs with the preset gap, they are rarely ever wrong...the electrode > is tough as hell and doesn't bend easily.. > > I agree also, Bosch Plats are crap, I'd throw them away if that's what > you got, get Motorcraft or Autolite for it... > > I, for one, would be interested in hearing what, exactly, is "crap" about the Bosch plugs. Resistors? Metallurgy? Ceramic composition? Where do they fail in your testing? What type of testing did you subject them to? What is it, exactly, that makes them inferior to other spark plugs? |
#7
|
|||
|
|||
Car shaking after changing spark plugs
Plat Bosch's in a 97 Lumina 3.1, replaced OE plats at 70k, at 22k Bosch's
began misfire under load, pulled em out the center electrode had eroded below the insulator, put oe's in another 70k no problem, field test seemed to indicate they wouldn't work in this car. "*" > wrote in message news:01c6c9dc$a5ce8100$da96c3d8@race... > > > jeffcoslacker > wrote in article > >... >> >> >> I'll cocurr with the others...cracked insulator or damaged plug wire >> most likely, gap not so much so, but possible...if they were platinum >> plugs with the preset gap, they are rarely ever wrong...the electrode >> is tough as hell and doesn't bend easily.. >> >> I agree also, Bosch Plats are crap, I'd throw them away if that's what >> you got, get Motorcraft or Autolite for it... >> >> > > > I, for one, would be interested in hearing what, exactly, is "crap" about > the Bosch plugs. > > Resistors? Metallurgy? Ceramic composition? > > Where do they fail in your testing? > > What type of testing did you subject them to? > > What is it, exactly, that makes them inferior to other spark plugs? > > ----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==---- http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups ----= East and West-Coast Server Farms - Total Privacy via Encryption =---- |
#8
|
|||
|
|||
Car shaking after changing spark plugs
«» wrote: > Wei Hu wrote: > > > > Hi, > > > > Today I replaced the six spark plugs of my 94 Ford Taurus. > > However, when I stop for red lights, the car shakes every one or two > > seconds. > > Does anybody know the reason? > > Could it be that I didn't adjust the gap? > > > > Thanks, > > Wei > > Add to what Shep said: > Possibly destroyed a wire or several while changing plugs. I replaced my wire because I came into a new set for free, an that problem of yours I had for years went away. |
#9
|
|||
|
|||
Car shaking after changing spark plugs
* wrote:
> > jeffcoslacker > wrote in article > >... > > > > > > I'll cocurr with the others...cracked insulator or damaged plug wire > > most likely, gap not so much so, but possible...if they were platinum > > plugs with the preset gap, they are rarely ever wrong...the electrode > > is tough as hell and doesn't bend easily.. > > > > I agree also, Bosch Plats are crap, I'd throw them away if that's what > > you got, get Motorcraft or Autolite for it... > > > > > > I, for one, would be interested in hearing what, exactly, is "crap" about > the Bosch plugs. > > Resistors? Metallurgy? Ceramic composition? > > Where do they fail in your testing? > > What type of testing did you subject them to? > > What is it, exactly, that makes them inferior to other spark plugs? Don't know what is wrong with the suckers, but if you put them in a Jeep 4.2 carb engine and in most Jeep 4.0 FI engines, they will work for a few miles, then they carbon up and the engine starts running like crap, especially at idle. Pull them out, put some real plugs in like Champion and bingo, the engine runs well again. I have seen this well over a half dozen times in the last few years and the fix is always to toss the plugs out. Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's Canadian Off Road Trips Photos: Non members can still view! Jan/06 http://www.imagestation.com/album/pi...?id=2115147590 (More Off Road album links at bottom of the view page) |
#10
|
|||
|
|||
Car shaking after changing spark plugs
* wrote:
> jeffcoslacker > wrote in article > >... > >> >>I'll cocurr with the others...cracked insulator or damaged plug wire >>most likely, gap not so much so, but possible...if they were platinum >>plugs with the preset gap, they are rarely ever wrong...the electrode >>is tough as hell and doesn't bend easily.. >> >>I agree also, Bosch Plats are crap, I'd throw them away if that's what >>you got, get Motorcraft or Autolite for it... >> >> > > > > I, for one, would be interested in hearing what, exactly, is "crap" about > the Bosch plugs. > > Resistors? Metallurgy? Ceramic composition? > > Where do they fail in your testing? > > What type of testing did you subject them to? > > What is it, exactly, that makes them inferior to other spark plugs? > > I would guess in this case it's heat range. Heat range X isn't always the same across brands, and some cars are really sensitive about this. My buddy has a PT Cruiser that had the check engine light come on when it was a year old and there was a TSB on the plugs. Can't remember which brand was involved, but basically the TSB was "thou shalt ONLY use plug xyz in this engine or your Check Engine light will be on." I've bought used cars with 3 different brands of plugs without any issues, but some cars are just "picky" about the plugs. Ray |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
My 97 Toyota Tercel keeps burning out spark plugs | [email protected] | Technology | 3 | July 17th 06 07:42 PM |
AWA [OFFER] DENSO SPARK PLUGS | [email protected] | General | 0 | March 31st 06 05:51 PM |
changing spark plugs | tricky | VW air cooled | 1 | December 1st 05 03:32 AM |
2.0L Spark Plugs -- App Book Error | Brian Running | VW water cooled | 1 | August 21st 05 08:26 PM |
Opinion - Spark plugs for '98 3.0 Voyager | Ken Peterson | Chrysler | 24 | March 20th 05 02:04 AM |