If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cruise Control Problem?
I occasionally get the impression the cruise control on my 2000 Chrysler
Concorde LXi isn't operating properly. When set at about 60 mph, it occasionally feels like it down shifts. The RPMs rise to about 2900 to 3000 and I feel a shift in the transmission. The hill involved is from a series of "washboard type" that rise rather sharply then decline. The distance of the hills on any given rise or decline is perhaps a half mile at most; usually one quarter of a mile or less. It doesn't occur often. When it does though, I've begun simply shutting off the cruise control. On mostly flat stretches, everything is fine. Is this normal? |
Ads |
#2
|
|||
|
|||
"John Gregory" > wrote in message . .. > I occasionally get the impression the cruise control on my 2000 Chrysler > Concorde LXi isn't operating properly. When set at about 60 mph, it > occasionally feels like it down shifts. The RPMs rise to about 2900 to 3000 > and I feel a shift in the transmission. The hill involved is from a series > of "washboard type" that rise rather sharply then decline. The distance of > the hills on any given rise or decline is perhaps a half mile at most; > usually one quarter of a mile or less. It doesn't occur often. When it does > though, I've begun simply shutting off the cruise control. On mostly flat > stretches, everything is fine. Is this normal? > When climbing a grade the speed control tries to maintain the set speed by increasing the throttle opening, while inability/delaying downshifts.. If opening the throttle alone cannot maintain the set speed and the vehicle speed drops more than three mph below the set speed, the transmission will downshift to third gear. If the vehicle continues to lose speed, by more than 6 mph, the transmission will downshift again maintain the set speed. After the vehicle encounters a less-steep grade, or has crested the grade (reduced the load on the powertrain) and can maintain the set speed at a reduced throttle position, the transmission will upshift, as appropriate, until the set speed can be maintained in Overdrive. Glenn Beasley Chrysler Tech |
#3
|
|||
|
|||
I've never noticed anything "out of the ordinary" while going up hills. This
occurs only going downhill. Isn't the brake system supposed to come into play when doing downhill to reduce the speed. If set at 60 and I start picking up speed, I occasionally feel it shift and the RPMs run up to around 3000. That happens rarely... but it does happen. I thought perhaps the mechanism that's supposed to kick in the brakes wasn't doin' its job and the transmission took over. "maxpower" > wrote in message ... > > "John Gregory" > wrote in message > . .. >> I occasionally get the impression the cruise control on my 2000 Chrysler >> Concorde LXi isn't operating properly. When set at about 60 mph, it >> occasionally feels like it down shifts. The RPMs rise to about 2900 to > 3000 >> and I feel a shift in the transmission. The hill involved is from a >> series >> of "washboard type" that rise rather sharply then decline. The distance >> of >> the hills on any given rise or decline is perhaps a half mile at most; >> usually one quarter of a mile or less. It doesn't occur often. When it > does >> though, I've begun simply shutting off the cruise control. On mostly flat >> stretches, everything is fine. Is this normal? >> > > When climbing a grade the speed control tries to maintain the set speed > by > increasing the throttle opening, while inability/delaying downshifts.. > > If opening the throttle alone cannot maintain the set speed and the > vehicle > speed drops more than three mph below the set speed, the transmission will > downshift to third gear. If the vehicle continues to lose speed, by more > than 6 mph, the transmission will downshift again maintain the set speed. > After the vehicle encounters a less-steep grade, or has crested the grade > (reduced the load on the powertrain) and can maintain the set speed at a > reduced throttle position, the transmission will upshift, as appropriate, > until the set speed can be maintained in Overdrive. > > > > Glenn Beasley > > Chrysler Tech > > |
#4
|
|||
|
|||
"John Gregory" > wrote in message .. . > I've never noticed anything "out of the ordinary" while going up hills. This > occurs only going downhill. Isn't the brake system supposed to come into > play when doing downhill to reduce the speed. If set at 60 and I start > picking up speed, I occasionally feel it shift and the RPMs run up to around > 3000. That happens rarely... but it does happen. I thought perhaps the > mechanism that's supposed to kick in the brakes wasn't doin' its job and the > transmission took over. > > > "maxpower" > wrote in message > ... > > > > "John Gregory" > wrote in message > > . .. > >> I occasionally get the impression the cruise control on my 2000 Chrysler > >> Concorde LXi isn't operating properly. When set at about 60 mph, it > >> occasionally feels like it down shifts. The RPMs rise to about 2900 to > > 3000 > >> and I feel a shift in the transmission. The hill involved is from a > >> series > >> of "washboard type" that rise rather sharply then decline. The distance > >> of > >> the hills on any given rise or decline is perhaps a half mile at most; > >> usually one quarter of a mile or less. It doesn't occur often. When it > > does > >> though, I've begun simply shutting off the cruise control. On mostly flat > >> stretches, everything is fine. Is this normal? > >> > > > > When climbing a grade the speed control tries to maintain the set speed > > by > > increasing the throttle opening, while inability/delaying downshifts.. > > > > If opening the throttle alone cannot maintain the set speed and the > > vehicle > > speed drops more than three mph below the set speed, the transmission will > > downshift to third gear. If the vehicle continues to lose speed, by more > > than 6 mph, the transmission will downshift again maintain the set speed. > > After the vehicle encounters a less-steep grade, or has crested the grade > > (reduced the load on the powertrain) and can maintain the set speed at a > > reduced throttle position, the transmission will upshift, as appropriate, > > until the set speed can be maintained in Overdrive. > > > > > > > > Glenn Beasley > > > > Chrysler Tech Transmission control software includes an automatic speed control overspeed reduction feature. This maintains vehicle speed at the selected set point when descending a grade. The Transmission Control Module first senses that the speed control is set. If the set speed is exceeded by more than 4 mph and the throttle is closed, the TCM causes the transaxle to downshift to 3 rd gear. After downshifting, the automatic speed control resumes normal operation. To ensure that an upshiftis appropriate after the set speed is reached, the TCM waits until the speed control system opens the throttle at least 6 degrees before upshifting to overdrive again. If the driver applies the brakes, canceling automatic speed control operation with the transaxle still in 3rdgear, the TCM maintains this gear until the driver opens the throttle at least 6 degrees to avoid an inappropriate upshift. The upshift is also delayed for 2.5 seconds after reaching the 6 degrees throttle opening in anticipation that the driver might open the throttle enough to require 3rd gear. This will avoid unnecessary and disturbing transmission cycling. If the automatic speed control Resum feature is used after braking, the upshift is delayed until the set speed is achieved to reduce cycling and provide better response > > |
#5
|
|||
|
|||
Thanks. From your description, it appears everything is operating as
designed. Maybe I've simply not noticed the downshift in the past. I appreciate the explanation. "maxpower" > wrote in message ... > > "John Gregory" > wrote in message > .. . >> I've never noticed anything "out of the ordinary" while going up hills. > This >> occurs only going downhill. Isn't the brake system supposed to come into >> play when doing downhill to reduce the speed. If set at 60 and I start >> picking up speed, I occasionally feel it shift and the RPMs run up to > around >> 3000. That happens rarely... but it does happen. I thought perhaps the >> mechanism that's supposed to kick in the brakes wasn't doin' its job and > the >> transmission took over. >> >> >> "maxpower" > wrote in message >> ... >> > >> > "John Gregory" > wrote in message >> > . .. >> >> I occasionally get the impression the cruise control on my 2000 > Chrysler >> >> Concorde LXi isn't operating properly. When set at about 60 mph, it >> >> occasionally feels like it down shifts. The RPMs rise to about 2900 to >> > 3000 >> >> and I feel a shift in the transmission. The hill involved is from a >> >> series >> >> of "washboard type" that rise rather sharply then decline. The >> >> distance >> >> of >> >> the hills on any given rise or decline is perhaps a half mile at most; >> >> usually one quarter of a mile or less. It doesn't occur often. When it >> > does >> >> though, I've begun simply shutting off the cruise control. On mostly > flat >> >> stretches, everything is fine. Is this normal? >> >> >> > >> > When climbing a grade the speed control tries to maintain the set >> > speed >> > by >> > increasing the throttle opening, while inability/delaying downshifts.. >> > >> > If opening the throttle alone cannot maintain the set speed and the >> > vehicle >> > speed drops more than three mph below the set speed, the transmission > will >> > downshift to third gear. If the vehicle continues to lose speed, by >> > more >> > than 6 mph, the transmission will downshift again maintain the set > speed. >> > After the vehicle encounters a less-steep grade, or has crested the > grade >> > (reduced the load on the powertrain) and can maintain the set speed at >> > a >> > reduced throttle position, the transmission will upshift, as > appropriate, >> > until the set speed can be maintained in Overdrive. >> > >> > >> > >> > Glenn Beasley >> > >> > Chrysler Tech > > > Transmission control software includes an automatic speed control > overspeed > reduction feature. This maintains vehicle speed at the selected set point > when descending a grade. > The Transmission Control Module first senses that the speed control is > set. > If the set speed is exceeded by more than 4 mph and the throttle is > closed, > the TCM causes the transaxle to downshift to 3 rd gear. After > downshifting, > the automatic speed control resumes normal operation. To ensure that an > upshiftis appropriate after the set speed is reached, the TCM waits until > the speed control system opens the throttle at least 6 degrees before > upshifting to overdrive again. > > If the driver applies the brakes, canceling automatic speed control > operation with the transaxle still in 3rdgear, the TCM maintains this gear > until the driver opens the throttle at least 6 degrees to avoid an > inappropriate upshift. The upshift is also delayed for 2.5 seconds after > reaching the 6 degrees throttle opening in anticipation that the driver > might open the throttle enough to require 3rd gear. This will avoid > unnecessary and disturbing transmission cycling. If the automatic speed > control Resum feature is used after braking, the upshift is delayed until > the set speed is achieved to reduce cycling and provide better response > > >> >> > > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
The dangers of DRLs | 223rem | Driving | 399 | July 25th 05 11:28 PM |
VW Cruise Control Aircooled part ZVW 201 701 | Vdub144 | VW air cooled | 2 | June 15th 05 04:03 AM |
97 Caravan Cruise Control | JM | Chrysler | 2 | May 17th 05 08:09 PM |
'96 T & C temp control problem. | Fieronut | Chrysler | 6 | February 3rd 05 02:13 AM |
Cruise control Problems? | It DRIVES me crazy 2 | Driving | 72 | December 22nd 04 02:37 PM |