If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Dowel lost within engine case!!!
I meant to post a follow up a while back. Thanks for the suggestions.
The compressed air didn't work. I don't know how far down in there this thing is but it didn't pop out. Soooo...I'm getting a used engine case. It's the right thing to do. V (Vaughn M Hannon) wrote in message om>... > Man did I screw up. I'm reassembling my engine and I went to put the > first dowel in (closest to flywheel) and I stuck it in the hole where > oil comes out. I realized this might not be the right spot as I let > go and it slid down into the case and far, far away from me. So, > anyone, how am I going to retrieve my dowel so as to not ruin my newly > rebuilt engine when I go to run it? > > Any help is sooooo greatly appreciated. > > *sigh* > > Vaughn |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Where to get Official Speed Limit Info | [email protected] | Driving | 40 | January 3rd 05 07:10 AM |
Rotary Engine FAQ 0501 | Felix Miata | Driving | 0 | January 1st 05 12:27 PM |
3.3L downshifting by self after replacing Engine | Bob Warmen | Chrysler | 8 | October 12th 04 05:39 PM |