If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Pressure build up in 87 accord gas tank
I have a 1987 honda accord (carburetor).
Pressure is building up in the gas tank. I replaced the gas cap but it still happens. Any suggestions as to what else I could try? |
Ads |
#2
|
|||
|
|||
Pressure build up in 87 accord gas tank
"tonyce" > wrote in news:1168613244.701355.91230
@q2g2000cwa.googlegroups.com: > I have a 1987 honda accord (carburetor). > > Pressure is building up in the gas tank. I replaced the gas cap but it > still happens. > > Any suggestions as to what else I could try? > > How do you know pressure is building up? What tells you this? -- Tegger The Unofficial Honda/Acura FAQ www.tegger.com/hondafaq/ |
#3
|
|||
|
|||
Pressure build up in 87 accord gas tank
tonyce wrote:
> I have a 1987 honda accord (carburetor). > > Pressure is building up in the gas tank. I replaced the gas cap but it > still happens. > > Any suggestions as to what else I could try? > leave it alone. it's the evaporative control system working normally. |
#4
|
|||
|
|||
Pressure build up in 87 accord gas tank
I had this on my 86 accord. I was used to a small release of pressure and a
whoosh when removing the gas cap, but it got more and more pronounced until it was like opening a carbonated beverage. Finally pressure built up so high that it forced gas past the o-rings on the carburetor float and flooded the engine. I traced it to a blockage in the vent line of the evaporative control system. There is some sort of valve in the tank that connects to the cannister in the engine compartment. I used a vacuum pump to suck on the end of the hose and it opened up. Since then everything is back to normal, small release of pressure when removing the cap. "tonyce" > wrote in message ps.com... >I have a 1987 honda accord (carburetor). > > Pressure is building up in the gas tank. I replaced the gas cap but it > still happens. > > Any suggestions as to what else I could try? > |
#5
|
|||
|
|||
Pressure build up in 87 accord gas tank
Thanks for the info. I did some further checks on a honda manual and
became aware of the "2 way check valve" which allows vapors to escape to the charcoal canister. Where did you attach the pump? To the line coming from the fuel tank where it connects to the charcoal canister or close to the tank itself? Where exactly is this valve, do you have to drop the tank to get at it? As for the flooding problem, isn't the fuel tank cap supposed to release the pressure if it get beyond a certain threshold to avoid such problems? news.boeing.com wrote: > I had this on my 86 accord. I was used to a small release of pressure and a > whoosh when removing the gas cap, but it got more and more pronounced until > it was like opening a carbonated beverage. > > Finally pressure built up so high that it forced gas past the o-rings on the > carburetor float and flooded the engine. I traced it to a blockage in the > vent line of the evaporative control system. There is some sort of valve in > the tank that connects to the cannister in the engine compartment. I used a > vacuum pump to suck on the end of the hose and it opened up. Since then > everything is back to normal, small release of pressure when removing the > cap. > > > "tonyce" > wrote in message > ps.com... > >I have a 1987 honda accord (carburetor). > > > > Pressure is building up in the gas tank. I replaced the gas cap but it > > still happens. > > > > Any suggestions as to what else I could try? > > |
#6
|
|||
|
|||
Pressure build up in 87 accord gas tank
Thanks for the info. I did some further checks on a honda manual and
became aware of the "2 way check valve" which allows vapors to escape to the charcoal canister. Where did you attach the pump? To the line coming from the fuel tank where it connects to the charcoal canister or close to the tank itself? Where exactly is this valve, do you have to drop the tank to get at it? As for the flooding problem, isn't the fuel tank cap supposed to release the pressure if it get beyond a certain threshold to avoid such problems? news.boeing.com wrote: > I had this on my 86 accord. I was used to a small release of pressure and a > whoosh when removing the gas cap, but it got more and more pronounced until > it was like opening a carbonated beverage. > > Finally pressure built up so high that it forced gas past the o-rings on the > carburetor float and flooded the engine. I traced it to a blockage in the > vent line of the evaporative control system. There is some sort of valve in > the tank that connects to the cannister in the engine compartment. I used a > vacuum pump to suck on the end of the hose and it opened up. Since then > everything is back to normal, small release of pressure when removing the > cap. > > > "tonyce" > wrote in message > ps.com... > >I have a 1987 honda accord (carburetor). > > > > Pressure is building up in the gas tank. I replaced the gas cap but it > > still happens. > > > > Any suggestions as to what else I could try? > > |
#7
|
|||
|
|||
Pressure build up in 87 accord gas tank
Yes, it was the 2 way check valve. Either it was stuck, or something was
stuck in the line between it and the cannister in the engine compartment. I disconnected the line in the engine compartment, then connected a 'Mighty-Mac' hand vacuum pump to the line. I forget how much pressure that 2-way valve is supposed to hold, but I was able to pull a considerable vacuum on the line before something gave way. Then it worked normally, a small amount of vacuum would open the valve and pressure was relieved. I believe that the factory cap is supposed to open and relieve pressure, but I lost that some time ago and have an after market. I could not see any pressure relief feature on it. The pressure definitely built to the point that it blew right past the o-rings on the float valve. I could see raw gas pouring down the throat of the carburetor. I wound up getting a carburetor gasket kit just to get the o-rings. I replaced those and things have been fine since. "tonyce" > wrote in message oups.com... > Thanks for the info. I did some further checks on a honda manual and > became aware of the "2 way check valve" which allows vapors to escape > to the charcoal canister. > > Where did you attach the pump? To the line coming from the fuel tank > where it connects to the charcoal canister or close to the tank itself? > Where exactly is this valve, do you have to drop the tank to get at it? > > As for the flooding problem, isn't the fuel tank cap supposed to > release the pressure if it get beyond a certain threshold to avoid such > problems? > > > news.boeing.com wrote: >> I had this on my 86 accord. I was used to a small release of pressure >> and a >> whoosh when removing the gas cap, but it got more and more pronounced >> until >> it was like opening a carbonated beverage. >> >> Finally pressure built up so high that it forced gas past the o-rings on >> the >> carburetor float and flooded the engine. I traced it to a blockage in >> the >> vent line of the evaporative control system. There is some sort of valve >> in >> the tank that connects to the cannister in the engine compartment. I >> used a >> vacuum pump to suck on the end of the hose and it opened up. Since then >> everything is back to normal, small release of pressure when removing the >> cap. >> >> >> "tonyce" > wrote in message >> ps.com... >> >I have a 1987 honda accord (carburetor). >> > >> > Pressure is building up in the gas tank. I replaced the gas cap but it >> > still happens. >> > >> > Any suggestions as to what else I could try? >> > > |
#8
|
|||
|
|||
Pressure build up in 87 accord gas tank
Upon a little further thought, perhaps applying pressure to the line would
be more effective since debris from the tank that might plug the valve would be forced back into the tank. I may have done vacuum and pressure on the line, it's been a while so I'm not that sure. The Mighty-Mac can do either. "tonyce" > wrote in message oups.com... > Thanks for the info. I did some further checks on a honda manual and > became aware of the "2 way check valve" which allows vapors to escape > to the charcoal canister. > > Where did you attach the pump? To the line coming from the fuel tank > where it connects to the charcoal canister or close to the tank itself? > Where exactly is this valve, do you have to drop the tank to get at it? > > As for the flooding problem, isn't the fuel tank cap supposed to > release the pressure if it get beyond a certain threshold to avoid such > problems? > > > news.boeing.com wrote: >> I had this on my 86 accord. I was used to a small release of pressure >> and a >> whoosh when removing the gas cap, but it got more and more pronounced >> until >> it was like opening a carbonated beverage. >> >> Finally pressure built up so high that it forced gas past the o-rings on >> the >> carburetor float and flooded the engine. I traced it to a blockage in >> the >> vent line of the evaporative control system. There is some sort of valve >> in >> the tank that connects to the cannister in the engine compartment. I >> used a >> vacuum pump to suck on the end of the hose and it opened up. Since then >> everything is back to normal, small release of pressure when removing the >> cap. >> >> >> "tonyce" > wrote in message >> ps.com... >> >I have a 1987 honda accord (carburetor). >> > >> > Pressure is building up in the gas tank. I replaced the gas cap but it >> > still happens. >> > >> > Any suggestions as to what else I could try? >> > > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Proper Radiator Cap Pressure Rating for 1994 Honda Accord EX? | Gary Kaucher | Honda | 65 | August 20th 06 05:41 AM |
OEM Honda Microfiche parts catalogs for sale | Joe | Honda | 0 | March 4th 06 07:30 PM |
OEM Honda parts catalogs for sale | Joe | Honda | 0 | February 20th 06 11:44 PM |
79 gas tank pressure | Roger Smallwood | Corvette | 6 | February 7th 06 05:08 PM |
Strong Vapour Pressure in Gas Tank? | Geoff Glave | Technology | 4 | June 3rd 05 05:00 AM |