If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How can you tell?
How can you tell if you broke a piston or not?? Other than taking the
engine apart.... |
Ads |
#2
|
|||
|
|||
How can you tell?
wrote:
> How can you tell if you broke a piston or not?? Other than taking the > engine apart.... Exactly what kind of broke? One check for noise the other check for compression. You may use an endoscope to take a look through the spark plug hole into a cylinder. This method they use to check valves inner sides and pistons. Regards, Ralf -- www.omnibusclub.de Erfinder des Abgasturboladers Dr. Alfred J. Büchi: "Die Abgase, deren noch inne-wohnende Energie bis dahin vergeudet wurde ..." |
#3
|
|||
|
|||
How can you tell?
Ralf Ballis wrote: > wrote: > > > How can you tell if you broke a piston or not?? Other than taking the > > engine apart.... > > Exactly what kind of broke? > One check for noise the other check for compression. > You may use an endoscope to take a look through the spark plug hole into a > cylinder. This method they use to check valves inner sides and pistons. > > Regards, > > Ralf > -- > www.omnibusclub.de > Erfinder des Abgasturboladers Dr. Alfred J. Büchi: "Die Abgase, > deren noch inne-wohnende Energie bis dahin vergeudet wurde ..." And if you have a hole in the oil pan or the side of the block, shine a flashlight right through that hole. |
#4
|
|||
|
|||
How can you tell?
|
Thread Tools | |
Display Modes | |
|
|