If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
RkFast wrote:
> Took out a pin and replaced it with NEW one from Acura. The pin was very > loose in the bracket hole. So it appears that whoever did the rebuilt > "bored" out these holes and they are just plain too big. Odd. One would think they'd match the pins to the caliper... I just installed a reman caliper on my Civic, and the pins came with it, as I assume they did with yours. Got mine OEM, and the pins fit perfectly. Hope you can recoup the cost of the bad calipers. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Heater boxes loose casing | Fred | VW air cooled | 1 | April 6th 05 12:35 AM |
Reassembly of caliper, to much pressure on outside rotor | Vince | Technology | 6 | January 10th 05 10:56 PM |
98 accord rear brake caliper | John Edwards | Technology | 4 | January 4th 05 03:19 AM |
stuck caliper... | Abeness | Honda | 113 | December 7th 04 01:22 AM |