If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
"California" Bocar 34Pict3 vacuum connections
I have this new bocar 34pict3 california version carb. It is the one with
the throttle positioner. It has some vacuum hose fittings different than the normal 34Pict3. One is at the very back middle. One is at the back near the bottom. This one is already connected to the throttle positioner. There is one on the left side at the bottom of the bowl. There is one on the right near the top of the bowl. On normal 34Pict3s there is a fitting on the left in the middle. The cali version doesn't have this fitting. Looks like it has a place that you could drill out and put one there but it doesn't come with one. Anyway, I have a electronic ignition distributor (no vacuum canister). So my question is what the heck do I do with the 3 vacuum connections on the carb? And since there are 3, what do they normally hook to? Gary |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 7 | February 1st 05 01:43 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 16th 04 05:28 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 1st 04 05:24 AM |
"California" Bocar 34Pict3 | GaryH | VW air cooled | 0 | October 29th 04 02:06 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | October 16th 04 05:28 AM |