If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Who was it who mentioned Fram oil filters and dropping oil pressure?
> wrote in message > And the filter did NOT split. It just "blew off". Took the threads > right out of the base plate. SHOULD have blown the gasket out first, > but didn't I have never seen that, in all my days. It takes one hell of a lot of pressure (or very weak threads) to do something like this. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Who was it who mentioned Fram oil filters and dropping oil pressure? | Hachiroku $B%O%A%m%/(B[_2_] | Dodge | 389 | January 2nd 10 10:36 PM |
Who was it who mentioned Fram oil filters and dropping oil pressure? | hls | Technology | 1 | December 14th 09 08:57 PM |
Who was it who mentioned Fram oil filters and dropping oil pressure? | jim | Technology | 0 | December 14th 09 01:47 PM |
Who was it who mentioned Fram oil filters and dropping oil pressure? | hls | Technology | 0 | December 8th 09 01:04 PM |