If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Brake stop plate on pans
I'm about to remove the drivers side front floor pan section, and noticed
that the new pan section doesn't come with a mount for the brake stop plate. Due to the amount of previous repair/patches on my existing floor, I can't tell how the plate mounts. It's just screwed into a mound of rust/paint/fiberglass. Does anyone have pictures of what this should look like on a new pan? Would I need to weld a reinforcing plate above, or below the new pan (crappy brazilian metal, I'd never go that route again) Thanks in advance, Mike Kayer |
Ads |
#2
|
|||
|
|||
After you get your pan in and your pedal cluster mounted, figure out
where the brake pedal stop needs to go. The drill a hole in the middle of the slot and weld a nut on the bottom of the pan. You can then bolt the pedal stop from the top. MK wrote: > I'm about to remove the drivers side front floor pan section, and noticed > that the new pan section doesn't come with a mount for the brake stop plate. > Due to the amount of previous repair/patches on my existing floor, I can't > tell how the plate mounts. It's just screwed into a mound of > rust/paint/fiberglass. Does anyone have pictures of what this should look > like on a new pan? Would I need to weld a reinforcing plate above, or below > the new pan (crappy brazilian metal, I'd never go that route again) > > Thanks in advance, > Mike Kayer > > > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Soft brake persists after Brake Fluid Flush. | [email protected] | Honda | 12 | June 18th 05 02:29 AM |
96 High mounted stop lamp (center brake light) | Ratbert | Ford Explorer | 9 | March 16th 05 04:23 AM |
Best way to put a brake stop on a tsw pedal unit | Brian Bowles | Simulators | 3 | February 7th 05 09:50 PM |
Brake rotors already grooving | [email protected] | Technology | 46 | January 15th 05 03:42 PM |
How to replace brake lines on 1976 Rabbit? | HerHusband | VW water cooled | 0 | January 1st 05 02:08 AM |