If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
87 325is issue...
My son's 87 325is has developed an issue and I'm hoping for some
solid advice on where to look. I'll be putting it up on a lift tomorrow and hope I can find the problem but I'm looking for advice here. The car has developed what I can only describe as a hop type vibration in the drivetrain. I can compare it to a u-joint vibration but it's more intense. Things I'll be looking at tomorrow are the guibo's and the axle half shafts. I know they have a CV joint in them but I've never seen one do this. I also have a jingling coming from the front tire but since the ABS light came on today I think the ABS ring has come off the hub. I've heard people talk about this... Thanks... |
#2
|
|||
|
|||
87 325is issue...
Psycho wrote:
> My son's 87 325is has developed an issue and I'm hoping for some > solid advice on where to look. I'll be putting it up on a lift > tomorrow and hope I can find the problem but I'm looking for advice > here. The car has developed what I can only describe as a hop type > vibration in the drivetrain. I can compare it to a u-joint vibration > but it's more intense. Things I'll be looking at tomorrow are the > guibo's and the axle half shafts. I know they have a CV joint in them > but I've never seen one do this. I also have a jingling coming from > the front tire but since the ABS light came on today I think the ABS > ring has come off the hub. I've heard people talk about this... > Thanks... I think you will find it is the guibo. When that goes it can cause a large offset in the driveline. It might also be one of the U joints, but not likely the center joint as that would just cause the floor of the car to shake. I'm sure it will be obvious when you start poking around... -- -Fred W |
#3
|
|||
|
|||
87 325is issue...
Fred W wrote:
> > I think you will find it is the guibo. When that goes it can cause a > large offset in the driveline. It might also be one of the U joints, > but not likely the center joint as that would just cause the floor of > the car to shake. I'm sure it will be obvious when you start poking > around... While I usually suspect the center bearing carrier *first*. It doesn't much matter. Whenever you replace one of these, it usually makes sense to replace both. They're both cheap and easy. They are also much more likely culprits than anything having to do with either the U joint or the half shafts. BTW, unless the E30 is different from the E28, if it has an automatic transmission, it will have no guibo. -- C.R. Krieger (Been there; done that) P.S.: If you're not familiar with the term, 'guibo' is the flexible rubber disk (also referred to as a 'flex disk') at the rear end of the transmission that links the driveshaft to the output flange. |
#4
|
|||
|
|||
87 325is issue...
I think there is a shaft extension on the transmission that engages a
bushing in the driveshaft to assure proper alignment of the driveshaft regardless of the condition of the guibo. I suppose the bushing could be damaged but I haven't seen that happen. Psycho, could you try to explain what you mean by hop type vibration? At what speeds is it apparent? Is there any accompanying noise? I had an experience on my 318i where it developed a vibration that seemed to be at the same frequency as the drive shaft rotation. It was most pronounced at about 35 mph where the car 'sounded like a pickup truck with snow tires on it'. After removing the drive shaft and finding nothing wrong I discovered the problem to be a front wheel bearing. The balls rolling over the dent in the inner race just happened to be at the same frequency as the drive shaft and the impulse was resonating with the coil spring producing quite a loud noise. Anyway good luck finding it. Jack "Fred W" > wrote in message ... > Psycho wrote: >> My son's 87 325is has developed an issue and I'm hoping for some >> solid advice on where to look. I'll be putting it up on a lift >> tomorrow and hope I can find the problem but I'm looking for advice >> here. The car has developed what I can only describe as a hop type >> vibration in the drivetrain. I can compare it to a u-joint vibration >> but it's more intense. Things I'll be looking at tomorrow are the >> guibo's and the axle half shafts. I know they have a CV joint in them >> but I've never seen one do this. I also have a jingling coming from >> the front tire but since the ABS light came on today I think the ABS >> ring has come off the hub. I've heard people talk about this... >> Thanks... > > I think you will find it is the guibo. When that goes it can cause a > large offset in the driveline. It might also be one of the U joints, but > not likely the center joint as that would just cause the floor of the car > to shake. I'm sure it will be obvious when you start poking around... > > -- > -Fred W |
#5
|
|||
|
|||
87 325is issue...
On Thu, 09 Mar 2006 08:51:58 -0500, Fred W
> wrote: >Psycho wrote: >> My son's 87 325is has developed an issue and I'm hoping for some >> solid advice on where to look. I'll be putting it up on a lift >> tomorrow and hope I can find the problem but I'm looking for advice >> here. The car has developed what I can only describe as a hop type >> vibration in the drivetrain. I can compare it to a u-joint vibration >> but it's more intense. Things I'll be looking at tomorrow are the >> guibo's and the axle half shafts. I know they have a CV joint in them >> but I've never seen one do this. I also have a jingling coming from >> the front tire but since the ABS light came on today I think the ABS >> ring has come off the hub. I've heard people talk about this... >> Thanks... > >I think you will find it is the guibo. When that goes it can cause a >large offset in the driveline. It might also be one of the U joints, >but not likely the center joint as that would just cause the floor of >the car to shake. I'm sure it will be obvious when you start poking >around... Well, my suspicions (and all of yours) were correct. The guibo had basically self destructed on me. Looks like I'll be going back to the BMW dealership tomorrow to get a guibo ($70) and most likely a center carrier bearing ($??). Can't see replacing one without the other and I missed the cutoff for getting it the Bavarian Autosport for delivery tomorrow... |
#6
|
|||
|
|||
87 325is issue...
Psycho wrote:
> > Well, my suspicions (and all of yours) were correct. The guibo had > basically self destructed on me. Looks like I'll be going back to the > BMW dealership tomorrow to get a guibo ($70) and most likely a center > carrier bearing ($??). The center carrier bearing is ~$35 or so, IIRC. Frankly, both together are probably less to repair than what you were suspecting. Glad we could be of assistance. BTW, if you're doing much dealershhip service, you really ought to be in BMW CCA. Very few dealers do not offer at least a 10-15% club discount on everything. -- C.R. Krieger (Been there; done that) |
#7
|
|||
|
|||
87 325is issue...
The dealer here wanted $115 for the carrier bearing assembly. I
replaced the bearing itself (not the whole unit) for $17. Don't really do much dealer stuff as my car is older and they don't really have much for it. On 15 Mar 2006 13:47:24 -0800, "E28 Guyİ" > wrote: >Psycho wrote: >> >> Well, my suspicions (and all of yours) were correct. The guibo had >> basically self destructed on me. Looks like I'll be going back to the >> BMW dealership tomorrow to get a guibo ($70) and most likely a center >> carrier bearing ($??). > >The center carrier bearing is ~$35 or so, IIRC. Frankly, both together >are probably less to repair than what you were suspecting. Glad we >could be of assistance. > >BTW, if you're doing much dealershhip service, you really ought to be >in BMW CCA. Very few dealers do not offer at least a 10-15% club >discount on everything. |
#8
|
|||
|
|||
87 325is issue...
Psycho wrote:
> The dealer here wanted $115 for the carrier bearing assembly. I > replaced the bearing itself (not the whole unit) for $17. Huh? How'd you do *that*? ISTR it's all one piece and the bearing is bonded to the rubber web of the carrier. I can believe you got a good deal on the whole thing, since I paid about the same amount for my last one. I'm a little stunned at the dealer price unless it includes installation. > Don't really > do much dealer stuff as my car is older and they don't really have > much for it. You've got the wrong dealer. Get thee over to MyE28.com and find Brian Da Parts Pimp. Parts guy at BMW of Chattanooga who can and will get you anything BMW has anywhere worldwide - at the best possible price. -- C.R. Krieger (Been there; done that) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
"Check Engine" issue. | maxpower | Chrysler | 0 | March 4th 06 12:51 PM |
Jeep Wagoneer Limited Transmission issue | [email protected] | 4x4 | 2 | February 27th 06 02:46 PM |
Jeep Wagoneer Limited Transmission issue | [email protected] | Chrysler | 0 | February 26th 06 11:52 PM |
Jeep Wagoneer Limited Transmission issue | [email protected] | Technology | 0 | February 26th 06 11:51 PM |
325is wiper issue | Omar | BMW | 0 | November 24th 04 07:48 AM |