Turn Signal help!

199 Isuzu rodeo. Turn signals just stopped working. They do not flash.
Bulbs, lights work fine because Hazards flash in both directions as
normal. I also check the fuse and it is fine as well. Any thoughts?
It's probably an electrical problem in the turn signal stem or dash.

I know that cleaning the turn signal stem may fix the problem, but how
do I disassemble the steering column, etc?

thank you!

Don't assume because the hazards work OK that the problem isn't
the turn signal flasher. They are two separate and different
pieces.

Pop

> wrote in message
ups.com...
> 199 Isuzu rodeo. Turn signals just stopped working. They do not
> flash.
> Bulbs, lights work fine because Hazards flash in both
> directions as
> normal. I also check the fuse and it is fine as well. Any
> thoughts?
> It's probably an electrical problem in the turn signal stem or
> dash.
>
> I know that cleaning the turn signal stem may fix the problem,
> but how
> do I disassemble the steering column, etc?
>
> thank you!
>

The hazard lights use a different flasher and a different fuse than the
signals. You can 'usually' swap over the flasher unit from the hazards
to test the signal one.

Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Canadian Off Road Trips Photos: Non members can still view!
Jan/06 http://www.imagestation.com/album/pi...?id=2115147590
(More Off Road album links at bottom of the view page)

" wrote:
>
> 199 Isuzu rodeo. Turn signals just stopped working. They do not flash.
> Bulbs, lights work fine because Hazards flash in both directions as
> normal. I also check the fuse and it is fine as well. Any thoughts?
> It's probably an electrical problem in the turn signal stem or dash.
>
> I know that cleaning the turn signal stem may fix the problem, but how
> do I disassemble the steering column, etc?
>
> thank you!