If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Emulate injectors - how?
Dodge Durango 99 5.9L, converted to run on LPG (single point). When running
on LPG injectors are disconnected to prevent them from working (or rather the common positive lead is routed thru resistor so that voltage drop on injectors is insufficient for them to operate), and naturally PCM complains about open injector circuits. Alldata is pretty vague about P0201-P0208 codes, and only says "if induction kick is not detected PCM will set the code". Apparently it checks not just for correct resistance but also for the 'inductive kick'. Anybody knows how to properly emulate injectors on this engine? Peter |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fule Injectors - 93 3.3 Grand Caravan | ncs | Chrysler | 1 | February 19th 05 01:30 AM |
24# Injectors | c4_4ya | Corvette | 2 | January 27th 05 03:07 PM |
Replace all injectors | Empty3 | Corvette | 20 | November 10th 04 12:28 AM |
Modifying a TB setup with larger injectors??? | AndyW | 4x4 | 11 | September 5th 04 06:41 PM |