vents blow alr out the defrost and florr

I have a 1995 mustang v6 the air con works but about two weeks ago it
started to only come out the defrost and floorboard it doen't matter what
the control is set on any suggestions
Rick

On Mon, 20 Jun 2005 11:14:43 -0500, "richard" > wrote:

>I have a 1995 mustang v6 the air con works but about two weeks ago it
>started to only come out the defrost and floorboard it doen't matter what
>the control is set on any suggestions
>Rick
>

replacr the blend door
LMFAO
h
u
r
c
a
s
t

Check the small black hard plastic tube that runs along the back of the

firewall from the heater fittings to the vacuum "T" next to the brake
booster. It is VERY common for this vacuum line to get brittle and
break. Without vacuum the vents will default to the defrost position at

the windshield. If broken place a piece of small vacuum hose between
the break. If broken at rubber fitting on the end where it goes to the
"T", drill it out and reinsert tube back into rubber and super glue.

Hope this is helpful,


TIM (Musttanguy)
PonyPerformance.com

> wrote in message
...
> On Mon, 20 Jun 2005 11:14:43 -0500, "richard" > wrote:
>
>>I have a 1995 mustang v6 the air con works but about two weeks ago it
>>started to only come out the defrost and floorboard it doen't matter what
>>the control is set on any suggestions
>>Rick
>>
>
> replacr the blend door
> LMFAO
> h
> u
> r
> c
> a
> s
> t
>

Yes! "Replacr" it immediately!

If I wanted to see the moron's posts I wouldn't have him blocked. It's
clear that to avoid the troll I must also filter Brian. Plonk

Brian wrote:

(richard) wrote in <UXBte.63149$gc6.2562@okepread04>:

>I have a 1995 mustang v6 the air con works but about two weeks ago it
>started to only come out the defrost and floorboard it doen't matter what
>the control is set on any suggestions
>Rick
>
>

I had a simular issue with my 97 v6. Found a vacumme line in the engine
compartment near the firewall that had become disconnected. After
reconnecting it all vent modes worked.

Yep, this happened on mine; did what Tim says and it's good as new.

John

"Musttanguy" > wrote in message oups.com...
> Check the small black hard plastic tube that runs along the back of the
>
> firewall from the heater fittings to the vacuum "T" next to the brake
> booster. It is VERY common for this vacuum line to get brittle and
> break. Without vacuum the vents will default to the defrost position at
>
> the windshield. If broken place a piece of small vacuum hose between
> the break. If broken at rubber fitting on the end where it goes to the
> "T", drill it out and reinsert tube back into rubber and super glue.
>
> Hope this is helpful,
>
>
> TIM (Musttanguy)
> PonyPerformance.com
>

vacum leak
"richard" > wrote in message
news:UXBte.63149$gc6.2562@okepread04...
>I have a 1995 mustang v6 the air con works but about two weeks ago it
>started to only come out the defrost and floorboard it doen't matter what
>the control is set on any suggestions
> Rick
>

"Pete Sampogna" > wrote in news:J0lye.9374$SQ1.2662
@fe09.lga:

> vacum leak

My buddy took his '96 Contour in to have the tranny rebuilt, and got it
back doing the same thing. They had broken a small vacuum line off at the
firewall. Look for broken vacuum lines.

--
"This space for rent."